본문 바로가기

Effect of Mo content on core-rim formation and mechanical properties of TiC/Fe-based composites

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q1Scopus Q1
피인용
Web of Science 0Scopus 0
JCR IF
JCR 2024 7
ISSN
0921-5093

저자

  1. 박현재제1저자Pusan Natl Univ, Sch Mat Sci & Engn, Busan, South Korea
  2. 이태호Pusan Natl Univ, Sch Mat Sci & Engn, Busan, South Korea
  3. 정다운Pusan Natl Univ, Sch Mat Sci & Engn, Busan, South Korea
  4. Cho, SeungchanKorea Inst Mat Sci, Composites & Convergence Mat Res Div, Chang Won, South Korea
  5. Lee, Sang-BokKorea Inst Mat Sci, Composites & Convergence Mat Res Div, Chang Won, South Korea
  6. Lee, Sang-KwanKorea Inst Mat Sci, Composites & Convergence Mat Res Div, Chang Won, South Korea
  7. 김양도교신저자Pusan Natl Univ, Sch Mat Sci & Engn, Busan, South Korea
  8. Kim, Junghwan교신저자Korea Inst Mat Sci, Composites & Convergence Mat Res Div, Chang Won, South Korea

초록

The mechanical response of ceramic-reinforced metal matrix composites is governed by the coupled effects of matrix deformation, load-bearing capacity of the ceramic reinforcement, and load transfer across the reinforcement/matrix interface. The relative contributions of these factors depend on the applied loading mode. In this study, TiC/Fe composites containing 50 vol% TiC were fabricated by liquid-phase sintering with 0-4 at.% Mo addition to the Fe matrix, in order to investigate the effects of Mo on core-rim evolution, rim/Fe interfacial characteristics, and mechanical behavior under different loading modes. Mo addition enhanced densification and promoted the formation of a Mo-enriched (Ti,Mo)C rim, while Mo dissolution into the Fe matrix remained limited. The mechanical properties exhibited distinct composition-dependent trends depending on the loading mode. The 3Mo composite exhibited the highest mean compressive strength, together with the highest measured rim hardness, suggesting that the enhanced local deformation resistance of the rim contributed to its compressive load-bearing capacity. Under tensile loading, the 2Mo composite exhibited the highest mean strength and was characterized by the smallest local rim/Fe lattice misfit, the largest estimated misfit-accommodation spacing, and the lowest fraction of interfacial debonding. Its relatively high TiC particle-cracking fraction suggested that the reinforcement sustained a substantial portion of the applied load before fracture, while premature interfacial separation was suppressed. Overall, these results demonstrate that Mo addition modifies both the local deformation resistance of the (Ti,Mo)C rim and the rim/Fe interfacial characteristics, with their relative effects on the mechanical response depending on the loading mode.

키워드

TiC/Fe compositeMo additionCore-rim structureLiquid-phase sinteringInterfacial coherencyLattice misfitMETAL-MATRIX COMPOSITES316L STAINLESS-STEELMISFIT DISLOCATIONSPARTICLE-SIZEAB-INITIOMICROSTRUCTUREBEHAVIORCARBIDEINTERFACESSTRENGTH

식별자

Scopus EID
2-s2.0-105051717883
WoS UID
001894302300001