Sequential acid-base liquefaction of castor oil for low-molecular-weight polyol precursors
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q2Scopus Q1
- 저널
- POLYMER BULLETIN83(8) · #442 · 2026
- 피인용
- Web of Science 0Scopus 0
- FWCI (Scopus)
- 0
- JCR IF
- JCR 2024 4
- ISSN
- 0170-0839
저자
- Jeon, Young Chan제1저자PUcore R&D Ctr, 255 Yongjam Ro, Ulsan 44784, South Korea
- 민진규Pusan Natl Univ, Dept Polymer Sci & Engn, Busan 46241, South Korea
- 임원빈Pusan Natl Univ, Dept Polymer Sci & Engn, Busan 46241, South Korea
- 이주홍Pusan Natl Univ, Dept Polymer Sci & Engn, Busan 46241, South Korea
- 이재룡Pusan Natl Univ, Dept Polymer Sci & Engn, Busan 46241, South Korea
- 김성호Pusan Natl Univ, Dept Polymer Sci & Engn, Busan 46241, South Korea
- 배지홍교신저자Pusan Natl Univ, Res Inst Drug Dev, Busan 46241, South Korea
- 허필호교신저자Pusan Natl Univ, Dept Polymer Sci & Engn, Busan 46241, South Korea
초록
Castor oil was converted into low-molecular-weight, hydroxyl-functional polyol mixtures through a sequential acid-base liquefaction route, and the influence of reaction sequence on ester-linkage cleavage behavior and product distribution was evaluated in comparison with alkali-only caustic fusion and single-catalyst control reactions. In the sequential process, an acid-catalyzed first step promoted initial ester scission, while subsequent neutralization and mild alkaline treatment shifted the product distribution toward lower-molecular-weight, tetrahydrofuran-soluble species. Molecular-weight characteristics were assessed by gel permeation chromatography and are discussed as apparent values obtained under a consistent calibration protocol. Under the optimized sequential condition, the resulting polyol exhibited a lower apparent number-average molecular weight (Mn approximate to 519 g/mol), a narrower apparent molecular-weight distribution, and the highest low-molecular-weight fraction within the 300-700 g/mol range (51.4%) among the routes evaluated. Fourier-transform infrared analysis showed reduced ester carbonyl intensity together with increased hydroxyl-related absorption, consistent with progressive ester cleavage and hydroxyl generation. The sequential product also showed the highest hydroxyl value (1053.7 mg KOH/g), indicating enhanced formation of hydroxyl-functional low-molecular-weight species. Compared with the acid-only and base-only treatments, the sequential route provided a favorable balance between molecular-weight reduction and product uniformity within the tested analytical framework. These results indicate that sequential acid-base liquefaction provides a practical comparative route to low-molecular-weight castor-oil-derived polyol precursors with a narrower apparent molecular-weight distribution.
키워드
Castor oilBio-based polyolsAcid-base liquefactionCaustic fusionEster cleavagePolyol precursorsPOLYURETHANESCATALYSIS
식별자
- Scopus EID
- 2-s2.0-105043507657
- WoS UID
- 001778644800001



로그인
연구물 목록으로