Influence of ultrasonic nanocrystalline surface modification on age-hardening kinetics and precipitation behavior in extruded AZ91 magnesium alloy
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1Scopus Q1
- 저널
- JOURNAL OF ALLOYS AND COMPOUNDS1064 · 2026
- 피인용
- Web of Science 1Scopus 0
- FWCI (Scopus)
- 0
- JCR IF
- JCR 2024 6.3
- ISSN
- 0925-8388
저자
- Kim, Hyun Ji제1저자Agcy Def Dev, R&D Inst 2, Daejeon 34060, South Korea
- Hong, Won PyoKyungpook Natl Univ, Dept Mat Sci & Met Engn, Daegu 41566, South Korea
- Amanov, AuezhanTampere Univ, Fac Engn & Nat Sci, Tampere 33720, Finland
- Yu, HuiHebei Univ Technol, Sch Mat Sci & Engn, Tianjin 300130, Peoples R China
- 이태경Pusan Natl Univ, Sch Mech Engn, Busan 46241, South Korea
- Kim, Young MinKorea Inst Mat Sci, Dept Magnesium, Chang Won 51508, South Korea
- Park, Sung Hyuk교신저자Kyungpook Natl Univ, Dept Mat Sci & Met Engn, Daegu 41566, South Korea
초록
The limited strength of Mg alloys relative to Al alloys and steels restricts their structural application and motivates improved precipitation-strengthening strategies. In this study, ultrasonic nanocrystalline surface modification (UNSM) was applied to an extruded AZ91 magnesium alloy (Mg–9Al–0.8Zn–0.2Mn, wt.%) to examine its influence on precipitation kinetics and the age-hardening response during subsequent aging at 200 °C. UNSM generated a gradient-deformed surface layer (∼500 µm thick) with a high density of twins and dislocations, increasing the surface hardness to 158.6 HV, a 166% improvement over the as-extruded condition (59.5 HV). During aging, the UNSM-treated alloy exhibited a markedly accelerated hardening response, reaching a peak hardness of 138.1 HV after only 15 min, whereas the untreated alloy required 16 h to attain a lower peak hardness of 90.4 HV. X-ray diffraction confirmed that UNSM introduced no new phases, while aging resulted in the formation of Mg17Al12 precipitates. The high density of lattice defects in the UNSM-affected layer promoted the rapid formation of fine Mg17Al12 continuous precipitates (CPs) within grains and suppressed the formation of coarse discontinuous precipitates (DPs) along grain boundaries. Consequently, the peak-aged microstructure of the UNSM-treated alloy contained a higher density of fine CPs and a reduced fraction of lamellar DPs. The combined application of UNSM and short-duration aging produced a precipitate-induced hardness gradient concentrated in the near-surface region. These results demonstrate that surface severe plastic deformation induced by UNSM can significantly accelerate age-hardening and enable pronounced gradient strengthening in wrought Mg–Al-based alloys.
키워드
Age-hardeningAZ91 alloyPrecipitationSurface hardnessUltrasonic nanocrystalline surface modification
식별자
- Scopus EID
- 2-s2.0-105035033677
- WoS UID
- 001743604200001



로그인
연구물 목록으로