Cl2/Ar and Cl2/O2 Inductively Coupled Plasma Etching of (-201) β-Ga2O3
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- KCISCIEScopus
- 저널 순위
- JCR Q3Scopus Q2KCI Q4
- 저널
- Electronic Materials Letters22(1) · pp.8 · 2026
- 피인용
- Web of Science 0Scopus 0KCI 0
- FWCI (Scopus)
- 0
- JCR IF
- JCR 2024 2.6
- ISSN
- 1738-8090
저자
- 최병수제1저자Pusan Natl Univ, Dept Nano Fus Technol, Miryang 50463, Gyeongnam, South Korea
- 채기헌Pusan Natl Univ, Dept Nanomechatron Engn, Busan 46241, South Korea
- 황승구Pusan Natl Univ, Dept Nanomechatron Engn, Busan 46241, South Korea
- 김진곤Pusan Natl Univ, Dept Nanomechatron Engn, Busan 46241, South Korea
- Lee, Byeong WooKorea Maritime & Ocean Univ, Dept Ocean Adv Mat Convergence Engn, Busan 49112, South Korea
- Ryu, Jeong HoKorea Natl Univ Transportat, Dept Mat Sci & Engn, Chungju 27469, Chungbuk, South Korea
- Pearton, Stephen J.Univ Florida, Dept Mat Sci & Engn, Gainesville, FL 32611 USA
- 조현교신저자Pusan Natl Univ, Dept Nanomechatron Engn, Busan 46241, South Korea
초록
A comparative study of Cl-2/Ar and Cl-2/O-2 inductively coupled plasma etching of (-201) beta-Ga2O3 was performed, and the effect of additive gases on the etch characteristics was studied. In both plasma chemistries, as Cl-2 content increased, the etch rate continuously increased and the highest etch rates were obtained at 80% Cl-2 content. In the 40Cl(2)/10Ar and 40Cl(2)/10O(2) ICP discharges, the etch rate initially increased with increasing ICP source power up to 600 W and then decreased above 600 W, while the etch rate showed a strong dependence on the rf chuck power. The Cl-2/Ar ICP discharges produced significantly higher etch rates than the Cl-2/O-2 plasmas and maximum etch rates of similar to 97 nm/min and similar to 40 nm/min were obtained in the 40Cl(2)/10Ar and 40Cl(2)/10O(2) ICP discharges, respectively. Under all plasma compositions investigated, the surfaces etched in the Cl-2/Ar plasmas exhibited a constant normalized O/Ga ratio of similar to 0.85, which was somewhat lower than that of the unetched surface. The original stoichiometry was maintained on the Ga2O3 surfaces etched in the 40Cl(2)/10O(2) ICP discharges while a significant preferential desorption of oxygen atoms was observed for the Ga2O3 surfaces etched in the Cl-2/O-2 ICP discharges with Cl-2 content below 60%. Pattern transfer with better anisotropy was achieved with the Cl-2/Ar ICP discharges due to energetic Ar+ ion-assisted nature of the etching.
키워드
(-201) beta-Ga2O3Inductively coupled plasma etchingCl-2/ArCl-2/O-2Near-surface stoichiometry
식별자
- Scopus EID
- 2-s2.0-105021254879
- WoS UID
- 001609722100001
- KCI
- ART003293881



로그인
연구물 목록으로