Effect of spot-weld line orientation on formability for patchwork blank
- 문서 유형
- 연구출판물 · 학술대회 발표논문
- 등재
- Scopus
- 저널 순위
- Scopus Q4
- 저널
- KEY ENGINEERING MATERIALS729 · pp.86 · 2017
- 피인용
- Scopus 0
- FWCI (Scopus)
- 0
- ISSN
- 1013-9826
저자
- Ye, K. Y.제1저자Interdisciplinary Department for Innovative Manufacturing Engineering, Pusan National University, Geumjeong-gu, Busan, South Korea
- 김재홍Division of Precision and Manufacturing Systems, Pusan National University, Geumjeong-gu, Busan, South Korea
- 김병민교신저자School of Mechanical Engineering, Pusan National University, Geumjeong-gu, Busan, South Korea
초록
In recent years, in order to achieve weight reduction and crashworthiness, automotive part was manufactured using patchwork blanks. The smaller patches were welded on a main sheet to achieve a local reinforcement, which is called the patchwork. In this study, the effect of the spot-weld line orientation on the formability of patchwork blanks for high-strength low alloy(HSLA) steel was investigated in uni-axial tension mode by limiting dome height(LDH) test. A FE-analysis and experiment was performed to gain a better understanding of the formability for limiting dome height and strain distribution. As a result of the LDH test and FE-analysis, differences in the dome heights and forming limits were observed patchwork blanks with spot-weld line orientation of 0°, 45°, and 90°, respectively. For the 0° and 45° patchwork blanks, the dome heights was lower than those of 90° patchwork blanks because of the stress concentration in the pole side.
키워드
FormabilityOrientationPatchwork blankSpot-weldTailored blank
식별자
- Scopus EID
- 2-s2.0-85013909953



로그인
연구물 목록으로