Working Load Analysis of a 42 kW Class Agricultural Tractor According to Tillage Type and Gear Selection during Rotary Tillage Operation
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1Scopus Q2
- 저널
- AGRICULTURE-BASEL13(8) · #1556 · 2023
- 피인용
- Web of Science 7Scopus 7
- FWCI (Scopus)
- 0.62
- JCR IF
- JCR 2022 3.6
- ISSN
- 2077-0472
저자
- 김연수제1저자Pusan Natl Univ, Dept Bioind Machinery Engn, Miryang 50463, South Korea
- 배보민Pusan Natl Univ, Dept Bioind Machinery Engn, Miryang 50463, South Korea
- Kim, Wan-SooKyungpook Natl Univ, Dept Bioind Machinery Engn, Daegu 41566, South Korea
- Kim, Yong-Joo교신저자Chungnam Natl Univ, Dept Biosyst Machinery Engn, Daejeon 34134, South Korea
- Lee, Sang-DaeKorea Inst Ind Technol KITECH, Smart Agr R&D Grp, Gimje 54325, South Korea
- Kim, Taek-Jin교신저자TYM R&D Ctr, Dept Drive Syst Team, Iksan 54576, South Korea
초록
The objective of this study was to analyze the effect of tillage type (i.e., primary and secondary tillage) and gear selection (P1L2 to P1L4) on the working load of tractor-implement systems during rotary tillage. Soil properties change with depth, and differences in properties along the depth distribution, such as the location of formation of the hardpan layer, internal friction angle, and moisture content, affect the load of rotary tillage operations. Therefore, the physical properties of soil along the field depth distribution were measured to analyze the effect of tillage type and gear selection on workload in rotary tillage. In addition, a load measurement system equipped with PTO torque meter, axle torque meter, proximity sensor, and RTK-GPS were configured on the 42 kW agricultural tractor. The experimental results show that the combination of tillage type and gear selection has a wide-ranging effect on the tractor's workload and performance when the rotavator operated at the same tilling depth. Overall working load was higher by up to 14% (engine) and 29.1% (PTO shaft) in primary tillage compared to secondary tillage when the gear selection was the same. When the tillage type is the same, it was analyzed that the overall average torque increased by up to 35.9% (engine) and 33.9% (PTO shaft) in P1L4 compared to P1L2 according to gear selection. Based on load analysis results, it was found that the effect of gear selection (Engine: 4-14%, PTO: 12.1-28.6%) on engine and PTO loads was higher than that of tillage type (Engine: 31.6-35.1%, PTO: 31.9-32.8%), and the power requirement tended to decrease in secondary tillage. Therefore, working load should be considered according to the soil environment and tillage type when designing agricultural machinery system.
키워드
working loadagricultural tractorrotary tillagesoil propertytillage typeFORCE REQUIREMENTSPTO LOADPERFORMANCETRANSMISSIONSPEEDDRAFT
식별자
- Scopus EID
- 2-s2.0-85168674951
- WoS UID
- 001056943600001



로그인
연구물 목록으로