본문 바로가기

Mechanical and Microstructural Properties of Autogenous Arc Welds of 2 GPa Strength Hot-Press-Forming Steel

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q3Scopus Q2
피인용
Web of Science 2Scopus 2
FWCI (Scopus)
0.09
JCR IF
JCR 2023 2.2
ISSN
1059-9495

저자

  1. 김광수제1저자Pusan Natl Univ, Sch Mat Sci & Engn, Pusan 46241, South Korea
  2. Park, HanjiPortland State Univ, Dept Mech & Mat Engn, Portland, OR 97201 USA
  3. 강남현교신저자Pusan Natl Univ, Sch Mat Sci & Engn, Pusan 46241, South Korea
  4. Kang, SanghoonKorea Inst Ind Technol, Adv Joining & Addit Mfg R&D Dept, Incheon 21999, South Korea
  5. Kang, MinjungKorea Inst Ind Technol, Adv Joining & Addit Mfg R&D Dept, Incheon 21999, South Korea
  6. Kim, Cheolhee교신저자Portland State Univ, Dept Mech & Mat Engn, Portland, OR 97201 USA

초록

Currently, the strength of hot-press-forming steel has been increased to produce lightweight vehicles, and in this study, the first arc welding investigation on a 2.0 GPa-strength hot-press-forming steel was conducted. Hot-press-forming steel sheets with thicknesses of 1.1 mm were butt-welded by gas tungsten arc welding without a filler metal, with the heat input controlled in the range of 140-260 J/mm. The weld metal, coarse-grained heat-affected zone (HAZ), and fine-grained HAZ had martensitic microstructures. The softened zone was composed of an intercritical HAZ (with polygonal ferrite and martensite/bainite) and a subcritical HAZ (with tempered martensite). The intercritical HAZ was softened the most during welding and fractured during tensile testing. The strengths of the arc welds were in the range of 1141-1264 MPa, which were 57-63% strength of the base metal. The equiaxed austenite on martensite or ferrite matrix was developed at the intercritical HAZ of gas tungsten arc welds, therefore transforming into the coarse martensite during quenching. However, the intercritical HAZ of laser welds indicated acicular austenite transforming into the fine martensite due to its high cooling rate. The intercritical HAZ softening was revealed to originate from carbon diffusion during the martensite to austenite transformation, which is unavoidable in arc welding and should be considered in the design of a welded structure.

키워드

arc weldingheat-affected zonehot-press-forming steelmicrostructuresofteningstrengthLASERTEMPERATUREMARTENSITEBLANKSJOINTS

식별자

Scopus EID
2-s2.0-85161921799
WoS UID
001008438400001