Effect of non-reactive diluent on defect-free debinding process of 3D printed ceramics
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1Scopus Q1
- 저널
- ADDITIVE MANUFACTURING67 · #103475 · 2023
- 피인용
- Web of Science 75Scopus 78
- FWCI (Scopus)
- 5.38
- JCR IF
- JCR 2022 11
- ISSN
- 2214-8604
저자
- 김지환제1저자Pusan Natl Univ, Sch Mat Sci & Engn, Pusan 46241, South Korea
- Gal, Chang WooKorea Inst Mat Sci, Dept Adv Biomat Res, Ceram Mat Div, Chang Won 51508, Gyeongsangnam D, South Korea
- Choi, Yeong-JinKorea Inst Mat Sci, Dept Adv Biomat Res, Ceram Mat Div, Chang Won 51508, Gyeongsangnam D, South Korea
- Park, HonghyunKorea Inst Mat Sci, Dept Adv Biomat Res, Ceram Mat Div, Chang Won 51508, Gyeongsangnam D, South Korea
- 윤석영교신저자Pusan Natl Univ, Sch Mat Sci & Engn, Pusan 46241, South Korea
- Yun, Hui-suk교신저자Korea Inst Mat Sci, Dept Adv Biomat Res, Ceram Mat Div, Chang Won 51508, Gyeongsangnam D, South Korea
초록
Defect-free three-dimensional (3D)-printed ceramics, such as alumina, zirconia, and titania, have been successfully fabricated by controlling the initial defect formation using a non-reactive diluent, namely, polypropylene glycol (PPG), as an additive in the photocurable resin. By crosslinking with uncured monomers in 3Dprinted ceramic green bodies, PPG prevented them from evaporating early, which often results in defect formation at low temperatures (<325 <degrees>C). PPG also decomposed before the main resin components, thereby forming interconnected pores, which consequently enabled gases from resin decomposition to escape throughout the green body. The effects of PPG addition on defect formation were systematically studied during the debinding process of an alumina slurry. In addition, defect formation was analyzed through thermogravimetric analysis, computed tomography 3D scanning, Fourier transform infrared spectroscopy, and differential scanning calorimetry. When the 3D-printed, crack-free alumina was sintered at 1650 degrees C, a 99.2% relative density was achieved. PPG was also applied to zirconia and titania to verify the versatility of PPG in various types of ceramic stereolithography-printed materials. The results suggested that PPG has excellent potential for fabricating various complex and large-volume ceramics without defects through stereolithography.
키워드
Ceramic 3D printingStereolithographyNon -reactive diluentThermal debindingDefect formation controlFABRICATIONPLASTICIZERCRACKING
식별자
- Scopus EID
- 2-s2.0-85150931108
- WoS UID
- 000951662200001



로그인
연구물 목록으로