Feasibility of using graphene as a substitute to graphite in the laser surface hardening of ferritic stainless steel
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1Scopus Q1
- 저널
- JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T23 · pp.3232 · 2023
- 피인용
- Web of Science 7Scopus 7
- FWCI (Scopus)
- 0.39
- JCR IF
- JCR 2022 6.4
- ISSN
- 2238-7854
저자
- 다니얄 아볼하사니제1저자Pusan Natl Univ, Sch Mech Engn, Ctr Innovat Technol Adv Forming, Busan 46241, South Korea
- 문병록Pusan Natl Univ, Sch Mat Sci & Engn, Busan 46241, South Korea
- 강남현Pusan Natl Univ, Sch Mat Sci & Engn, Busan 46241, South Korea
- VanTyne, Chester J.Colorado Sch Mines, Dept Met & Mat Engn, Golden, CO 80401 USA
- 문영훈교신저자Pusan Natl Univ, Sch Mech Engn, Ctr Innovat Technol Adv Forming, Busan 46241, South Korea
초록
The broad potential applications of ferritic stainless steel in industry can be increased with the addition of protective elements such as carbon for surface hardening. Laser surface hardening (LSH) using carbon elements, such as graphite, has received widespread attention. However, to obtain high quality results, the use of graphite slurry, a specific environment, or remelting are required. To overcome this challenge, the LSH using graphene as an alternative to graphite was comparatively studied in this work. Accordingly, the stability of hardened layers, which depicts their sustainability in actual environmental conditions, was compared in graphene, graphite, and their slurries to improve the evaluation of graphene in the LSH process. The stability of hardened layers predominantly depends on the hardness, crack susceptibility, interfacial stress, hardness depth (or aspect ratio), and interfacial hardness. Under suitable process conditions, graphene exhibits good stability, with the highest hardness and low stress fluctuation without crack formation at the interface. Moreover, the powder layer thickness and laser power can be adjusted to achieve maximum improvements in the aspect ratio and microhardness in the area near the interface. Thus, high microhardness and a crack-free hardened layer without additional remelting or the use of a slurry were obtained.
키워드
Ferritic stainless steelGrapheneGraphite slurryLaser surface hardeningMolecular dynamicSurface alloyingALLOYFECU
식별자
- Scopus EID
- 2-s2.0-85150028562
- WoS UID
- 000963907300001



로그인
연구물 목록으로