The effect of flange length on the distribution of longitudinal strain during the flexible roll forming process
- 문서 유형
- 연구출판물 · 학술대회 발표논문
- 등재
- Scopus
- 저널 순위
- Scopus Q4
- 저널
- MATERIALS SCIENCE FORUM920 MSF · pp.46 · 2018
- 피인용
- Scopus 5
- FWCI (Scopus)
- 0.63
- ISSN
- 0255-5476
저자
- 우영윤제1저자School of Mechanical Engineering, Pusan National University, South Korea
- 강필규School of Mechanical Engineering, Pusan National University, South Korea
- 오일영School of Mechanical Engineering, Pusan National University, South Korea
- 문영훈교신저자School of Mechanical Engineering, Pusan National University, South Korea
초록
Flexible roll forming is an advanced sheet metal forming process which allows the production of variable cross-section profiles. In flexible roll forming process, nonuniform transversal distribution of the longitudinal strain can cause the longitudinal bow, which is deviation in height of the web over the length of the profile. To investigate the effect of flange length on the transversal distribution of the longitudinal strain, FEM simulations are conducted with different flange length for three blank shapes; trapezoid, convex and concave. The result shows that the longitudinal strain and longitudinal bow decrease with increasing flange length for a trapezoid and a concave blank. For a convex blank, the longitudinal strain and longitudinal bow increase with increasing flange length. To validate FEM simulation result, numerically obtained longitudinal strain has been compared with experimental results.
키워드
FEM simulationFlange lengthFlexible roll formingLongitudinal bowLongitudinal strain
식별자
- Scopus EID
- 2-s2.0-85046344189



로그인
연구물 목록으로