본문 바로가기

Ultrasonic Assessment of Thickness and Bonding Quality of Coating Layer Based on Short-Time Fourier Transform and Convolutional Neural Networks

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q2Scopus Q2
저널
COATINGS11(8) · #909 · 2021
피인용
Web of Science 27Scopus 32
FWCI (Scopus)
1.12
JCR IF
JCR 2020 2.881
ISSN
2079-6412

저자

  1. 마리커브 카흐라몬 우글리 아자마트전제1저자Pusan Natl Univ, Sch Mech Engn, Busan 46241, South Korea
  2. 조윤호교신저자Pusan Natl Univ, Sch Mech Engn, Busan 46241, South Korea
  3. 김영환Pusan Natl Univ, Inst Nucl Safety & Management, Busan 46241, South Korea
  4. 김정남Pusan Natl Univ, Sch Mech Engn, Busan 46241, South Korea
  5. 박준필Pusan Natl Univ, Inst Nucl Safety & Management, Busan 46241, South Korea
  6. Yi, Jin-HakKorean Inst Ocean Sci & Technol, Coastal Dev & Ocean Energy Res Ctr, Busan 49111, South Korea

초록

Ultrasonic non-destructive analysis is a promising and effective method for the inspection of protective coating materials. Offshore coating exhibits a high attenuation rate of ultrasonic energy due to the absorption and ultrasonic pulse echo testing becomes difficult due to the small amplitude of the second echo from the back wall of the coating layer. In order to address these problems, an advanced ultrasonic signal analysis has been proposed. An ultrasonic delay line was applied due to the high attenuation of the coating layer. A short-time Fourier transform (STFT) of the waveform was implemented to measure the thickness and state of bonding of coating materials. The thickness of the coating material was estimated by the projection of the STFT into the time-domain. The bonding and debonding of the coating layers were distinguished using the ratio of the STFT magnitude peaks of the two subsequent wave echoes. In addition, the advantage of the STFT-based approach is that it can accurately and quickly estimate the time of flight (TOF) of a signal even at low signal-to-noise ratios. Finally, a convolutional neural network (CNN) was applied to automatically determine the bonding state of the coatings. The time-frequency representation of the waveform was used as the input to the CNN. The experimental results demonstrated that the proposed method automatically determines the bonding state of the coatings with high accuracy. The present approach is more efficient compared to the method of estimating bonding state using attenuation.

키워드

coating with high attenuationthickness and bonding statusultrasonic pulse-echoshort-time Fourier transform (STFT)convolutional neural networks (CNN)ADHESIVELY BONDED JOINTSMODEL-BASED ESTIMATIONNONDESTRUCTIVE EVALUATIONOF-FLIGHTFREQUENCYATTENUATIONALGORITHMSIGNALSCNN

식별자

Scopus EID
2-s2.0-85112623440
WoS UID
000688971800001