Laser dissimilar welding of CoCrFeMnNi-high entropy alloy and duplex stainless steel
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1Scopus Q1
- 저널
- JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY85 · pp.95 · 2021
- 피인용
- Web of Science 89Scopus 101
- FWCI (Scopus)
- 4.23
- JCR IF
- JCR 2020 8.067
- ISSN
- 1005-0302
저자
- Adomako, Nana Kwabena제1저자Department of Materials Science and Engineering, Hanbat National University, Yuseong-gu, Daejeon 34158, Republic of Korea
- 신기승Department of Materials Science and Engineering, Pusan National University, Busan, Republic of Korea
- Park, NokeunSchool of Materials Science and Engineering, Yeungnam University, 280 Daehak-ro, Gyeongbuk 38541, Republic of Korea
- Park, Kyoungtae교신저자Rare Metal R&D Group, Korea Institute of Industrial Technology, Incheon 21999, Republic of Korea
- Kim, Jeoung HanDepartment of Materials Science and Engineering, Hanbat National University, Yuseong-gu, Daejeon 34158, Republic of Korea
초록
High entropy alloys (HEAs) have superior mechanical properties that have enabled them to be used as structural materials in nuclear and aerospace applications. As a dissimilar joint design is required for these applications, we created a dissimilar joint between CoCrFeMnNi-HEA and duplex stainless steel (DSS) through laser beam welding; a technique capable of producing a sound joint between the two materials. Microstructure examination using SEM/EBSD/XRD analysis revealed that the weld metal (WM) exhibits an FCC phase regardless of the postweld heat treatment (PWHT) temperature (800 and 1000 degrees C) without forming detrimental intermetallic compounds or microsegregation. The heat-affected zone of the CoCrFeMnNi-HEA showed CrMn oxide inclusions while that of the DSS showed no inclusions. Moreover, a lower hardness was recorded by the WM compared to the base metal after welding. After PWHT, the hardness of the WM, CoCrFeMnNi-HEA, and DSS decreased with an increase in the PWHT temperature. However, the decrease in the hardness of the HEA was more significant than in the WM and DSS. The cause for this reduction in hardness was attributed to recrystallization and grain growth. In addition, a strength of 584 MPa with low ductility was recorded after welding. The obtained strength was lower than that of the BMs, but comparable to that of the welded CoCrFeMnNi-HEA. The application of PWHT resulted in over a 20% increment in ductility, with only a marginal reduction in strength. The deformation mechanism in the as-weld joint was mainly dominated by dislocation while that for the PWHT joint was twinning. We propose laser beam offset welding as a technique to improve the mechanical properties of the dissimilar joint, which will be the subject of future studies. (C) 2021 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.
키워드
High entropy alloysWeldingDuplex stainless steelPost-weld heat treatmentMECHANICAL-PROPERTIESTENSILE PROPERTIESBEHAVIORCASTMICROSTRUCTURESTABILITYWELDABILITYEVOLUTION
식별자
- Scopus EID
- 2-s2.0-85101056145
- WoS UID
- 000667953100010



로그인
연구물 목록으로