Hydrophobic stretchable polydimethylsiloxane films with wrinkle patterns prepared via a metal-assisted chemical etching process using a Si master mold
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q2Scopus Q1
- 저널
- JOURNAL OF APPLIED POLYMER SCIENCE138(19) · 2021
- 피인용
- Web of Science 14Scopus 14
- FWCI (Scopus)
- 0.69
- JCR IF
- JCR 2020 3.125
- ISSN
- 0021-8995
저자
- 이한빈제1저자School of Chemical Engineering, Pusan National University, Busan, Republic of Korea
- 채상민School of Chemical Engineering, Pusan National University, Busan, Republic of Korea
- 이아라School of Chemical Engineering, Pusan National University, Busan, Republic of Korea
- 김효정교신저자School of Chemical Engineering, Pusan National University, Busan, Republic of Korea
초록
We fabricated hydrophobic, stretchable, wrinkle-patterned polydimethylsiloxane (PDMS) films via a metal-assisted chemical etching (MACE) process using a Si master mold, which is a mask-free technique for fabricating large-area films. The wrinkle-patterned PDMS surface prepared via MACE exhibited high hydrophobicity and stretchability, which are difficult to achieve with wrinkle-patterned PDMS prepared via a conventional process, such as, plasma treatment, e-beam, or laser patterning. The contact angle of the wrinkled PDMS surface was dependent on the size of the micro/nanostructures, and the largest contact angle was 135.8 +/- 0.1 degrees for the film prepared under the optimum conditions. To confirm the applicability of the wrinkled PDMS films to flexible electronics, we tuned the mechanical properties by controlling the crosslinker ratio in the films. The Young's modulus ranged from 0.193 to 1.364 MPa depending on the crosslinker ratio, and the stress of the optimum film was 1.5 MPa under 250% strain.
키워드
applicationsfilmsmorphologynanostructured polymerssurfaces and interfacesFABRICATIONSILICONSURFACEMICROPDMSWETTABILITY
식별자
- Scopus EID
- 2-s2.0-85097623226
- WoS UID
- 000599330600001



로그인
연구물 목록으로