Fe-17Mn-5Si-5Cr 형상기억합금의 형상복원거동 및 기계적 특성에 미치는 Ni, Ti 및 C의 영향
Effect of Ni, C and Ti Addition on Shape Recovery Behavior and the Mechanical Properties of Fe-17Mn-5Si-5Cr Shape Memory Alloys
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- KCISCIEScopus
- 저널 순위
- JCR Q3Scopus Q2
- 저널
- Korean Journal of Metals and Materials58(10) · pp.660 · 2020
- 피인용
- Web of Science 9Scopus 9KCI 2
- FWCI (Scopus)
- 0
- JCR IF
- JCR 2019 1.146
- ISSN
- 1738-8228
저자
- 김도형제1저자Department of Materials Science and Engineering, Pusan National University, Busan 46241, Republic of Korea
- 김용환DI Corp., Ulsan 44914, Republic of Korea
- Oak, Jeong-JungDI Corp., Ulsan 44914, Republic of Korea
- Lee, JunghoonDepartment of Metallurgical Engineering, Pukyong National University, Busan 48547, Republic of Korea
- Park, Chan HeeAdvanced Metals Division, Korea Institute of Materials Science, Changwon 51508, Republic of Korea
- 이욱진교신저자Korea Institute of Industrial Technology, Yangsan 50623, Republic of Korea
- 박용호교신저자Department of Materials Science and Engineering, Pusan National University, Busan 46241, Republic of Korea
초록
Fe-Mn-Si based shape memory alloy is a new functional material that can be used to apply prestress to civil and structural components such as concrete structures. In this study, the effects of alloying elements Ni, C and Ti on the mechanical and shape memory properties of the alloy were investigated in detail using a base alloy composition of Fe-17Mn-5Si-5Cr (wt%). Enhanced shape recovery ratio and decreasing strength were observed in the alloy when 4 wt% Ni was added. With the further addition of 0.05 wt% C, the alloy showed even higher shape recovery behavior, although the mechanical strength was lowered by the C addition. Increasing the carbon content up to 0.1 wt% led to higher mechanical strength while the shape recovery ratio was decreased slightly. It was shown that the addition of 1 wt% Ti can significantly enhance the shape recovery behavior of the alloy. The recovery behavior of the alloy with the co-addition of 0.3 wt% C and 1 wt% Ti was similar to the alloy without Ti but containing 0 1 wt% C, even though the C content was significantly higher. The alloy with the co-addition of 0.3 wt% C and 1 wt% Ti has great potential as functional components in prestressed civil engineering structures, since the yield strength of the alloy is as high as 400 MPa in the solution heat treated condition and can be further improved by aging heat treatments, which precipitate TiC particles.
키워드
fe-shape memory alloyFe-Mn-Sishape recoverymechanical propertybendingmicrostructureTRANSFORMATION-INDUCED PLASTICITYSTACKING-FAULT ENERGYAUSTENITE STABILITYTENSILE BEHAVIORSTRESS FORMATIONCARBONDEFORMATIONTEMPERATUREIMPROVEMENTSILICON
식별자
- Scopus EID
- 2-s2.0-85092774641
- WoS UID
- 000580592500002
- KCI
- ART002633164



로그인
연구물 목록으로