본문 바로가기

Tribological and Nano-Scratch Properties of Aluminum (A356) Based Hybrid Composites Reinforced with MWCNTs/Alumina Fiber

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q1Scopus Q1KCI Q1
저널
METALS AND MATERIALS INTERNATIONAL27(9) · pp.3666 · 2021
피인용
Web of Science 6Scopus 5KCI 1
FWCI (Scopus)
0.4
JCR IF
JCR 2020 3.642
ISSN
1598-9623

저자

  1. 수레쉬바부제1저자교신저자Global Core Research Center for Ship and Offshore Plants (GCRC-SOP), Pusan National University, Busan, 46241, Republic of Korea
  2. Srinivasan, A.Materials Division, National Institute for Interdisciplinary Science and Technology, CSIR, Thiruvananthapuram, Kerala, 695019, India
  3. 강충길Engineering Research Center (ERC-NSDM), School of Mechanical Engineering, Pusan National University, Busan, 46241, Republic of Korea

초록

In this article, the tribological properties of aluminum/MWCNTs/Al(2)O(3sf)hybrid composites with varying volume fraction of 10 vol%, 15 vol% and 20 vol% was investigated under dry sliding conditions. The experiments were performed according to design of experiments approach using Taguchi method to predict the wear properties of composites. The results indicated that the composites of 15 vol% had lower wear loss, whereas the coefficient of friction (COF) decreased significantly at 20 vol%. Taguchi based ANOVA analysis showed that the sliding distance was found to be the prominent factor controlling the wear loss; applied load influenced COF most significantly. It could also be noticed that the COF and wear loss increases with an increase in sliding load and sliding distance. The decrease in wear loss and the COF can be attributed to the self-lubrication effect of MWCNTs, and the combined effect of reinforcements in the composites. In addition, nanoscratch test was performed to determine the COF and the effect of the reinforcements on local regions of the composites. The results revealed that higher friction force was obtained near the regions of MWCNTs and Al(2)O(3sf)while nanoscratching. The COF of composites of 20 vol% was found to slightly higher compared to that of 10 vol% and 15 vol%. This is attributed to the presence of MWCNTs cluster within the Al(2)O(3sf)network results prevent the micro-plastic deformation of Al matrix, and the formation of tribofilms with nanoscaled thickness in the scratch region. These friction and wear results indicate that the presence of a limited amount and size of MWCNTs clusters are beneficial to the tribological properties of the hybrid composites. Graphic

키워드

Aluminum compositesTaguchi methodWear testNanoscratchTribological propertiesMETAL-MATRIX COMPOSITESSLIDING WEAR BEHAVIORFABRICATIONBN

식별자

Scopus EID
2-s2.0-85087489575
WoS UID
000543587600001
KCI
ART002751658