본문 바로가기

Screw-in forces during instrumentation by various file systems

문서 유형
연구출판물 · 학술지 논문
등재
KCI
저널
RESTORATIVE DENTISTRY AND ENDODONTICS41(4) · pp.304 · 2016
피인용
KCI 1
ISSN
2234-7658

저자

  1. 하정홍제1저자경북대학교
  2. 김현철교신저자부산대학교
  3. 곽상원부산대학교
  4. 김성교경북대학교

초록

Objectives: The purpose of this study was to compare the maximum screw-in forces generated during the movement of various Nickel-Titanium (NiTi) file systems. Materials and Methods: Forty simulated canals in resin blocks were randomly divided into 4 groups for the following instruments: Mtwo size 25/0.07 (MTW, VDW GmbH), Reciproc R25 (RPR, VDW GmbH), ProTaper Universal F2 (PTU, Dentsply Maillefer), and ProTaper Next X2 (PTN, Dentsply Maillefer, n = 10). All the artificial canals were prepared to obtain a standardized lumen by using ProTaper Universal F1. Screwin forces were measured using a custom-made experimental device (AEndoS-k, DMJ system) during instrumentation with each NiTi file system using the designated movement. The rotation speed was set at 350 rpm with an automatic 4 mm pecking motion at a speed of 1 mm/sec. The pecking depth was increased by 1 mm for each pecking motion until the file reach the working length. Forces were recorded during file movement, and the maximum force was extracted from the data. Maximum screwin forces were analyzed by one-way ANOVA and Tukey’s post hoc comparison at a significance level of 95%. Results: Reciproc and ProTaper Universal files generated the highest maximum screw-in forces among all the instruments while M-two and ProTaper Next showed the lowest (p < 0.05). Conclusions: Geometrical differences rather than shaping motion and alloys may affect the screw-in force during canal instrumentation. To reduce screw-in forces, the use of NiTi files with smaller cross-sectional area for higher flexibility is recommended.

키워드

Continuous rotationGeometryNickel-titanium fileReciprocatingScrew-in force

식별자

KCI
ART002170852