본문 바로가기

1000MPa급 DP강 MIG 아크 브레이징 접합부의 기계적 성질에 미치는 브레이징 전류의 영향

Effects of Brazing Current on Mechanical Properties of Gas Metal Arc Brazed Joint of 1000MPa Grade DP Steels

문서 유형
연구출판물 · 학술지 논문
등재
KCI
저널
대한용접접합학회지35(2) · pp.23 · 2017
피인용
KCI 0
ISSN
2466-2232

저자

  1. 조욱제제1저자현대머티리얼 환경사업팀
  2. 윤태진교신저자부산대학교
  3. 곽승윤부산대학교 재료공학과
  4. 이재형부산대학교
  5. 강정윤교신저자부산대학교

초록

Mechanical properties and hardness distributions in arc brazed joints of Dual phase steel using Cu-Al insert metal were investigated. The maximum tensile shear load was 10.4kN at the highest brazing current. It was about 54% compared to tensile load of base metal. This joint efficiency is higher than that of joint of DP steel using Cu-based filler metals which are Cu-Si, Cu-Sn. Fracture positions can be divided into two types. Crack initiation commonly occurred at three point junction among upper sheet, lower sheet and the fusion zone. However crack propagations were different with increasing the brazing current. In case of the lower current, it instantaneously propagated along with the interface between fusion zone and upper base material. On the other hand, in case of higher current, a crack propagation occurred through fusion zone. When the brazing current is low (60, 70A), the interface shape is flat type. However the interface shape is rough type, when the brazing current is high (80A). It is thought that the interface shapes were the reason why the crack propagations were different with brazing current. The interface was the intermetallic compounds which consisted of (Fe,Al)0.85Cu0.15 IMC formed by crystallization at 1200℃during cooling. Therefore the maximum tensile shear load and the fracture behavior were determined by a interface shape and effective sheet thickness of the fracture position.

키워드

DP steelGas Metal Arc brazingCu-Si filler metalMicrostructureTensile shear test

식별자

KCI
ART002217991