Effect of Shaft Length on the Torsional Resistance of Rotary Nickel-titanium Instruments
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1Scopus Q1
- 저널
- JOURNAL OF ENDODONTICS46(2) · pp.295 · 2020
- 피인용
- Web of Science 5Scopus 5KCI 0
- FWCI (Scopus)
- 0
- JCR IF
- JCR 2019 3.118
- ISSN
- 0099-2399
저자
- Isik, Vasfiye제1저자Department of Endodontics, Division of Clinical Sciences, Faculty of Dentistry, Okan University, Istanbul, Turkey
- 곽상원Department of Conservative Dentistry, School of Dentistry, Dental Research Institute, Pusan National University, Yangsan, Korea
- Abu-Tahun, Ibrahim H.Department of Conservative Dentistry, School of Dentistry, The University of Jordan, Amman, Jordan
- Ha, Jung-HongDepartment of Conservative Dentistry, School of Dentistry, Kyungpook National University, Daegu, Korea
- Kayahan, Mehmet Baybora교신저자Department of Endodontics, Division of Clinical Sciences, Faculty of Dentistry, Okan University, Istanbul, Turkey
- 김현철Department of Conservative Dentistry, School of Dentistry, Dental Research Institute, Pusan National University, Yangsan, Korea
초록
Introduction: This study was conducted to evaluate the effect of file length on the torsional resistance of nickel-titanium rotary files. Methods: Forty-five new files with a #25 tip size and variable taper for ProTaper Next (PTN; Dentsply Sirona, York PA), ProTaper Gold (PTG, Dentsply Sirona), and HyFlex CM (HCM; Coltene-Whaledent, Allstetten, Switzerland) were divided into 3 subgroups (n = 15) according to the file length (21, 25, and 31 mm). Torsional tests were performed using a custom-made device (AEndoS; DMJ System, Busan, Korea). The maximum torsional load and distortion angle were measured until file fracture occurred. The toughness was calculated using these data. All data were statistically analyzed using 2-way analysis of variance at a confidence level of 95%. One-way analysis of variance and Duncan post hoc comparison were also conducted to assess the difference among the independent variables, shaft length, and file system. Results: A statistically significant interaction was observed between the file system and instrument length with respect to the maximum torsional load (P < .05). The 31-mm shaft length of HCM showed higher maximum torsional load than that of the 25- and 21-mm shaft length in the HCM groups (P < .05). Among the instrument systems, PTG showed the significantly highest maximum torsional load followed by PTN and HCM (P < .05). The 31-mm shaft length of PTG showed significantly higher toughness than that of the 21- and 25-mm shaft lengths (P < .05), whereas PTN and HCM did not show any difference in relation to the shaft length. Conclusions: Within the limitations of this study, the instrument with a longer shaft may have higher maximum torsional load or toughness than that with a shorter shaft.
키워드
File fractureinstrument lengthnickel-titanium fileshaft lengthtorsional resistanceCYCLIC FATIGUE RESISTANCEMECHANICAL-PROPERTIESUNIVERSALBEHAVIORPROTAPERFILES
식별자
- Scopus EID
- 2-s2.0-85076247551
- WoS UID
- 000512217000023



로그인
연구물 목록으로