본문 바로가기

압력용기 제조를 위한 D.D.I. 공정의 팁 클리어런스 설계

Design of Tip Clearance in the D.D.I. Process to Manufacture Pressure Vessel

문서 유형
연구출판물 · 학술지 논문
등재
KCIScopus
저널 순위
Scopus Q4
저널
한국정밀공학회지35(7) · pp.715 · 2018
피인용
Scopus 0KCI 0
FWCI (Scopus)
0
ISSN
1225-9071

저자

  1. 곽효서제1저자Research Institute of Mechanical Technology, Pusan National University, South Korea
  2. 박건영Department of Mechanical Convergence Technology, Pusan National University, South Korea
  3. 김철교신저자School of Mechanical Engineering, Pusan National University, South Korea

초록

The liner of CNG pressure vessel was manufactured using a deep drawing and ironing (D.D.I.) process with a single punch. Tip clearance between billet and die suggested in the actual field has been widely used to reduce forming load and to improve die life. However, the analysis and design of tip clearance is necessary for the third stage of forming defect. In this study, the tip clearance of the third stage was determined to limit the ratio of reduction of cross-sectional area based on theoretical analysis. The proposed tip clearance was verified via finite element analysis. In addition, the simulation technique was established by comparing the forming load based on theoretical calculation with the load determined via FEM.

키워드

압축천연가스 압력용기D.D.I. 공정팁 클리어런스유한요소해석성형하중CNG pressure vesselD.D.I. processTip clearanceFinite element analysisForming load

식별자

Scopus EID
2-s2.0-85049615134
KCI
ART002356592