Electrochemical Analysis of the Slurry Composition for Chemical Mechanical Polishing of Flexible Stainless-Steel Substrates
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q4Scopus Q3
- 저널
- JOURNAL OF FRICTION AND WEAR38(6) · pp.482 · 2017
- 피인용
- Web of Science 13Scopus 18
- FWCI (Scopus)
- 0.35
- JCR IF
- JCR 2016 0.514
- ISSN
- 1068-3666
저자
- 이다솔제1저자Department of Mechanical Engineering, Pusan National University, Busan, South Korea
- 김현진Department of Mechanical Engineering, Pusan National University, Busan, South Korea
- 박병준Department of Mechanical Engineering, Pusan National University, Busan, South Korea
- 김도연Korea Institute of Industrial Technology, Busan, South Korea
- 정해도교신저자Department of Mechanical Engineering, Pusan National University, Busan, South Korea
- Lee, HyunseopSchool of Mechanical Engineering, Tongmyong University, Busan, South Korea
초록
The surface quality of the stainless steel affects the efficiency of flexible photovoltaics. Chemical mechanical polishing (CMP) is a finishing process that is used to prepare substrates for electronic devices. The CMP slurry composition is an important factor because additives in the slurry generally improve the polishing performance. However, it is limited to find the optimum conditions for the slurry by only experimental approaches. Thus, this study uses electrochemical analysis and friction monitoring to examine the effects of the abrasive, oxidizer, chelating agent, and pH. Electrochemical and monitoring analysis are useful for validating predictions and understanding interactions between the slurry and the stainless steel surface. Good correspondence was found between the predictions and the polishing results in more accurate. The corrosion rate (CR) obtained from the potentiodynamic polarization curve is proportional to the experimental results, as is the behavior of the curve and the coefficient of friction (COF). After only 3 min CMP, the best performing slurry (abrasive 39 wt %, oxalic acid 1 wt %, H2O2 0.03 wt %, pH 1.5) improved the surface quality of 304 stainless steel by 4 nm. As a result, the proposed methods could help reduce the risks involved in stainless steel CMP slurry and these results could provide a reference for optimizing CMP slurry for flexible 304 stainless steel substrates.
키워드
chemical mechanical polishingelectrochemical analysisslurrystainless steelMATERIAL REMOVALOXIDIZER
식별자
- Scopus EID
- 2-s2.0-85042845079
- WoS UID
- 000426764800011



로그인
연구물 목록으로