Effects of Mo Content on Low-Angle Misorientation Microstructure and Mechanical Properties of YS 550 MPa-Grade Steels for Offshore Structures
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q2Scopus Q1
- 저널
- STEEL RESEARCH INTERNATIONAL89(2) · 2018
- 피인용
- Web of Science 12Scopus 13
- FWCI (Scopus)
- 0.89
- JCR IF
- JCR 2017 1.43
- ISSN
- 1611-3683
저자
- 김인제1저자Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
- 이명진Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
- 최윤석Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
- 강남현교신저자Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
초록
This study investigates the effects of Mo content on the low-angle misorientation microstructure and the mechanical properties of high strength steels of YS 550MPa grade. Steels of various Mo contents (0.08, 0.15, and 0.25wt%) are fabricated by controlled rolling and accelerated cooling. The Mo steels consist of acicular ferrite (AF), granular bainite (GB), a low-angle misorientation microstructure, that is, bainitic ferrite (BF), and a secondary phase of martensite-austenite (MA), regardless of the Mo content. Degenerated pearlite (DP) is observed only in the 0.08wt% Mo steel. As the Mo content increases from 0.08 to 0.25wt%, the microstructure and mechanical properties are described as follows: (i) the volume fraction of AF decreases and that of BF increases, (ii) the yield and tensile strengths increase and the elongation decreases, and (iii) the Charpy toughness at -60 degrees C decreases owing to the decrease in AF and increase in BF.
키워드
electron back-scattered diffraction (EBSD)metalsmicrostructuremolybdenumCARBON MICROALLOYED STEELPLASTIC-DEFORMATIONACICULAR FERRITELINEPIPE STEELSTRANSFORMATIONTEMPERATUREMOLYBDENUMBAINITESIMULATIONTOUGHNESS
식별자
- Scopus EID
- 2-s2.0-85041342498
- WoS UID
- 000423833200009



로그인
연구물 목록으로