Study on the influence of gear hobbing and shaft misalignments on the geometric interference of cylindrical worm gear set
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q3Scopus Q2
- 저널
- PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE231(24) · pp.4646 · 2017
- 피인용
- Web of Science 10Scopus 13
- FWCI (Scopus)
- 0.64
- JCR IF
- JCR 2016 1.015
- ISSN
- 0954-4062
저자
초록
Geometric interference can occur in cylindrical worm gear set that makes use of oversized hob to cut the worm gear. In particular, the interference occurs easily in the design with high lead and low pressure angles. The interference results in a corner contact. In this study, we examined the influence of the machine tool setting errors of the worm gear hobbing and the influence of the shaft misalignments of the worm gear set on the interference. To determine the interference, we used the surface separation topology based on differential geometry. In addition, we also examined the hob oversize range required to avoid the interference under the condition of the machine tool setting errors and shaft misalignments. This study found that the interference can be avoided not only when the hob oversize is larger than the upper limit, but also when the hob oversize is smaller than the lower limit. This study also found that the interference can be avoided by applying the intended errors on the machine tool setting and shaft alignment, without manipulating the hob oversize.
키워드
Worm gearhob oversizemisalignmentgear hobbinginterferenceLOADED TOOTH CONTACTOVERSIZE HOB CUTTERSCOMPUTERIZED DESIGNMATHEMATICAL-MODELBEARING CONTACTSSIMULATIONDRIVESGENERATIONCUTKLINGELNBERG
식별자
- Scopus EID
- 2-s2.0-85036454323
- WoS UID
- 000416547400012



로그인
연구물 목록으로