본문 바로가기

Fabrication and energy harvesting characteristics of unimorph piezoelectric cantilever generators with interdigitated electrode lead zirconate titanate laminates

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q3Scopus Q1
피인용
Web of Science 5Scopus 7
FWCI (Scopus)
0.39
JCR IF
JCR 2016 1.384
ISSN
0021-4922

저자

  1. 이민선제1저자Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
  2. Yun, Ji-SunElectronic Convergence Materials Division, Korea Institute of Ceramic Engineering and Technology, Jinju, Gyeongnam, South Korea
  3. Park, Woon-IkElectronic Convergence Materials Division, Korea Institute of Ceramic Engineering and Technology, Jinju, Gyeongnam, South Korea
  4. Hong, Youn-WooElectronic Convergence Materials Division, Korea Institute of Ceramic Engineering and Technology, Jinju, Gyeongnam, South Korea
  5. 조정호Electronic Convergence Materials Division, Korea Institute of Ceramic Engineering and Technology, Jinju, Gyeongnam, South Korea
  6. Paik, Jong-HooElectronic Convergence Materials Division, Korea Institute of Ceramic Engineering and Technology, Jinju, Gyeongnam, South Korea
  7. 박용호Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
  8. Son, Chun-MyungKEPCO KDN Co., Ltd., Jeonnam, Naju, South Korea
  9. Jeong, Young Hun교신저자Electronic Convergence Materials Division, Korea Institute of Ceramic Engineering and Technology, Jinju, Gyeongnam, South Korea

초록

Interdigitated electrode (IDE) unimorph piezoelectric cantilever generators (UPCGs) were fabricated and their energy harvesting characteristics were investigated. A hard lead zirconate titanate (PZT) material with a high mechanical quality factor (Q(m)) of 1280 was used for the active piezoelectric film of the IDE UPCGs. Two different laminated IDE UPCGs were prepared; one has Ag/Pd interdigitated electrode (IDE) formed only on the top and bottom PZT sheets (D-IDE), while the other has Ag/Pd IDE on all of the PZT sheets (M-IDE). Cofiring was conducted at 1050 degrees C for 2 h for PZT laminates with IDEs. The fabricated IDE UPCGs exhibited power densities of 50.4 mu W/cm(3) for the D-IDE and 820 mu W/cm(3) for the M-IDE. The UPCG with the M-IDE exhibited a higher performance than that with the D-IDE. Specifically, a significantly enhanced normalized power factor of 670 mu W/(g(2).cm(3)) was found at 118Hz across 100 k Omega. (c) 2017 The Japan Society of Applied Physics

키워드

POWER GENERATORTHIN-FILMSDESIGNMODEPERFORMANCEPZT

식별자

Scopus EID
2-s2.0-85039161420
WoS UID
000415862500001