본문 바로가기

Effect of Added Gas-Atomized Al-Si/SiCp Composite Powder on the Sinterability and Mechanical Properties of Alumix 431 fabricated by Hot-Pressing Process

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q2Scopus Q2
저널
Korean Journal of Metals and Materials55(2) · pp.98 · 2017
피인용
Web of Science 1KCI 0
JCR IF
JCR 2015 1.36
ISSN
1738-8228

저자

  1. 이은선제1저자부산대학교 재료공학부
  2. 옥정중DEA-IL Corporation
  3. 김용진한국기계연구원부설 재료연구소
  4. 박용호교신저자부산대학교

초록

The aim of this study is to establish an optimized hot-press sintering condition for aluminum matrix composites (AMCs) by analyzing their sintered microstructure and mechanical properties. The fabricated AMCs in this study consisted of a blend of commercial Ecka Alumix 431 powder, and Al-Si/SiCp, powder manufactured by gas atomizer (Al-Si/SiCp). The Al-Si/SiCp, powder was added to the Alumix 431 powder as a binder. The blended powder was hot-pressed and sintered and its properties were analyzed based on three variables: the blending ratio of each powder, sintering time and sintering temperature. The MgZn2 phases in the Alumix 431 powder were finely and homogeneously distributed when the sintering temperature was increased. The liquid phase of the Al-Si alloy facilitated densification of the Alumix 431 particles and promoted a reduction in pores in the sintered body. Dispersion of the MgZn2 phases, degree of porosity and densification of the fabricated AMCs affected the ultimate tensile strength (UTS) of the sintered body at room temperature (RT). The highest UTS of the fabricated AMCs was 242MPa at RT. The optimum sintering conditions were: a mixing ratio of Al-Si/SiCp to Alumix 431 powders of 5 to 95 wt%, a sintering time of 30 min and a sintering temperature of 610 degrees C. Wear behavior of the specimens prepared with the optimized sintering conditions included stick-slip, abrasive, adhesive and delamination phenomena for each test condition, under correlated vertical load and linear speed.

키워드

compositessinteringmechanical propertieswearscanning electron microscopy (SEM)METAL-MATRIX COMPOSITESZN-MGMICROSTRUCTURE EVOLUTIONPARTICLE DISTRIBUTIONSI ALLOYSWEARSTRENGTHCUPRECIPITATIONWETTABILITY

식별자

WoS UID
000393627200004
KCI
ART002195423