본문 바로가기

Effects of the shoulder diameter and weld pitch on the tensile shear load in friction-stir welding of AA6111/AA5023 aluminum alloys

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q1Scopus Q1
피인용
Web of Science 37
JCR IF
JCR 2016 3.147
ISSN
0924-0136

저자

  1. 박상원제1저자Graduate School of Convergence Science, Pusan National University, Busan, South Korea
  2. 윤태진교신저자Institute of Materials Technology, Pusan National University, Busan, South Korea
  3. 강정윤Dept. of Material Science and Engineering, Pusan National University, Busan, South Korea

초록

The heights of deformed interface and surface affected the tensile shear load of lap joints fabricated by friction stir welding. The influences of shoulder diameter, weld pitch and evolution of mechanical properties has been investigated experimentally. The heights of the softened surface decreased and the bonded area widened with increasing the SD. The interface transformed from a hooked shape to a flat interface with decreasing the WP. The peak load was obtained by increasing the SD and WP. Fractured positions were divided in two types, shear and tensile fracture. Shear fracture occurred at the interface which contains stir zone. Tensile fracture was observed at the thermo-mechanically affected zone of the top plate. The fracture mode indicating the peak load was the shear fracture rather than tensile fracture. This is because the exact position of shear fracture was where the base material penetrated the bottom plate. The larger SD and higher WP produced higher peak load because of widened bonded area and little deformation. But the peak load decreased inversely in case of the higher rotation speed over than 1500 rpm which means higher heat input conditions. (C) 2016 Elsevier B.V. All rights reserved.

키워드

Friction stir lap weldingDissimilar aluminum alloyShoulder diameterWeld pitchMechanical propertyMECHANICAL-PROPERTIESMICROSTRUCTURESTRENGTHJOINTS

식별자

WoS UID
000390182400012