본문 바로가기

Oil droplet behavior with the position of a muffler discharge hole in the shell of a rotary compressor

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q3Scopus Q2
저널
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY30(10) · pp.4579 · 2016
피인용
Web of Science 9KCI 0
JCR IF
JCR 2015 0.761
ISSN
1738-494X

저자

  1. 노기율제1저자부산대학교
  2. 민병채부산대학교
  3. 송상진부산대학교
  4. 양장식부산대학교
  5. 최경민교신저자부산대학교
  6. 김덕줄부산대학교

초록

In this study, high-frequency visualization in the compressor shell via optical glass was performed to confirm inner flow. Visualization experiments were conducted under actual operating conditions (suction pressure = 0.99 MPa, discharge pressure = 2.29 MPa, operating speed = 40, 60, 80 Hz) by using a calorimeter. Most oil droplets transferred to the upper cavity were observed at the coil winding area around the muffler discharge hole. Oil droplets released from the muffler hole collided with the lower face of the motor, because of the high discharge speed and the short distance between the motor and the muffler. In this process, a part of these oil droplets were directly induced into the coil winding area. According to the above-mentioned results, the vane installation to reduce the Oil circulation ratio (OCR) was considered through Computational fluid dynamics (CFD) simulation. The vane was installed inside the coil winding area around the muffler hole. As a result, the oil droplet velocity was decreased by vane, and an OCR reduction effect from 1.2 to 1.8% was predicted.

키워드

Oil droplet behaviorMuffler discharge holeHigh-speed visualizationOil circulation ratioRATIOMODEL

식별자

WoS UID
000386616700029
KCI
ART002152176