본문 바로가기

Manufacturing process of bezel frame for strength-reinforced TFT LCD module by progressive hemming of SUS304 stainless steel sheet

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q3Scopus Q2
저널
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY30(3) · pp.1103 · 2016
피인용
Web of Science 2KCI 0
JCR IF
JCR 2015 0.761
ISSN
1738-494X

저자

  1. Kyung-Hun Lee제1저자Korea Maritime and Ocean University
  2. 고대철부산대학교
  3. Jung-min LeeKorea Institute of Industrial Technology
  4. 이찬주한국생산기술연구원
  5. Seon-Bong LeeKeimyung University
  6. 김병민교신저자Pusan National University

초록

In this study, the design procedure for a progressive multi-hemming forming process has been proposed for manufacturing bezel frames for strength-reinforced TFT LCD (Thin-film-transistor liquid-crystal display) modules. First, a strength analysis was performed using Finite element (FE) simulations to determine the minimum number of required folding edges. Subsequently, anoother FE analysis was carried out in order to investigate the effects of the process parameters on the dimensional accuracy of the bezel frame and to design the progressive hemming process. The analytical results were validated by hemming experiments performed using SUS304 stainless steel with a thickness of 0.3 mm. Finally, the quality of the bezel frame was estimated through measurements of its dimensional accuracy and bending stiffness. From the experimental results, it was confirmed that a bezel frame with a height distribution of 1.5 +/- 0.05 mm and a respectable bending stiffness of 70 N/mm could be manufactured using the proposed process.

키워드

Bezel frameProgressive hemmingMulti-stage bendingBending stiffnessFORMING DEFECTSSURFACEDESIGNELIMINATIONPREDICTIONSPRINGBACKFORCE

식별자

WoS UID
000372238300014
KCI
ART002085874