본문 바로가기

Temperature-Dependent Evolution of Poly(3-Hexylthiophene) Type-II Phase in a Blended Thin Film

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q1Scopus Q1
저널
MACROMOLECULAR RAPID COMMUNICATIONS37(3) · pp.203 · 2016
피인용
Web of Science 4
JCR IF
JCR 2015 4.638
ISSN
1022-1336

저자

  1. 이시우제1저자부산대학교, 공과대학, 유기소재시스템공학과, KO
  2. 금희성부산대학교, 공과대학, 유기소재시스템공학과, KO
  3. 김한성부산대학교, 공과대학, 유기소재시스템공학과, KO
  4. 김효정교신저자부산대학교, 공과대학, 유기소재시스템공학과, KO
  5. Ahn, Kwangseok숭실대학교, Dept Phys, KO
  6. Lee, Dong Ryeol교신저자숭실대학교, Dept Phys, KO
  7. Kim, Je Han포항공과대학교, Pohang Accelerator Lab, KO
  8. Lee, Hyun Hwi교신저자포항공과대학교, Pohang Accelerator Lab, KO

초록

The structure of P3HT in P3HT:PCBM films is examined on a poly(3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS) substrate subjected to cryo-cooling to low temperature (-143 degrees C) followed by gradual heating to 50 degrees C. The behavior of these systems is examined in the absence and presence of an Al electrode on top of the P3HT:PCBM film. At temperatures below -10 degrees C, only the type-I phase of P3HT is observed. However, the type-II phase of P3HT starts to form near -10 degrees C, in both the presence and absence of the Al layer. In the system without an Al layer, the type-II phase disappears at 30 degrees C, but this phase persists to 50 degrees C in the presence of the Al layer. Concomitant with the formation of the type-II phase, a 1:3 ordered P3HT type-II (1/3,0,0) superlattice peak emerged. The type-II domains tend to form near the Al electrode layer and show a higher degree of alignment than the type-I crystals.

키워드

alignmentP3HTpolymorphsolvent mixturetype-II phaseHETEROJUNCTION SOLAR-CELLSBULK-HETEROJUNCTIONCRYSTALLINITY

식별자

WoS UID
000369834400001