Anisotropic Nanocrystalline Nd-Fe-B-Based Magnets Produced by Spark Plasma Sintering Technique
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q2Scopus Q2
- 저널
- IEEE TRANSACTIONS ON MAGNETICS51(11) · 2015
- 피인용
- Web of Science 8
- JCR IF
- JCR 2014 1.386
- ISSN
- 0018-9464
저자
- Liu, Shu제1저자Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
- 강남현Department of Materials Science and Engineering, Pusan National University, Busan, South Korea
- Feng, LunPowder and Ceramics Division, Korea Institute of Materials Science, Changwon, South Korea
- Lee, Sea-HoonPowder and Ceramics Division, Korea Institute of Materials Science, Changwon, South Korea
- Yu, Ji-HunPowder and Ceramics Division, Korea Institute of Materials Science, Changwon, South Korea
- Lee, Jung-Goo교신저자Powder and Ceramics Division, Korea Institute of Materials Science, Changwon, South Korea
초록
Anisotropic hot-deformed nanocyrstalline Nd-Fe-B magnets were prepared by spark plasma sintering technique using MQU-F melt-spun flakes. Magnetic properties with a coercivity of 20 kOe and (BH)(max) of over 17.5 MGOe were obtained for the isotropic magnet after hot pressing (HP) process, due to the formation of superfine nanocrystalline grains without grain growth and coarse grain regions. Anisotropic Nd-Fe-B magnets were obtained with 60% and 80% degrees of deformation after die upsetting (DU) process. The remanence of 13.9 kG and (BH)(max) of 45 MGOe were achieved for the anisotropic Nd-Fe-B magnets with 80% degree of deformation. A distinct two-region microstructure with fine plated-shaped region and coarse grain region was formed in the vicinity of the flake boundaries after hot deformation. The microstructure evolution from HP process to DU process and the effect on the magnetic properties were discussed in detail.
키워드
Hot deformation (HD)melt-spun flakesmicrostructureNd-Fe-B magnetsspark plasma sintering (SPS)HOT DEFORMATION
식별자
- WoS UID
- 000364770500116



로그인
연구물 목록으로