본문 바로가기

Fabrication of titanium bipolar plates by rubber forming and performance of single cell using TiN-coated titanium bipolar plates

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q2Scopus Q1
저널
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY39(36) · pp.21480 · 2014
피인용
Web of Science 81
JCR IF
JCR 2013 2.93
ISSN
0360-3199

저자

  1. 진철규제1저자부산대학교, 공과대학, 기계공학부, KO
  2. 정민근부산대학교, 공과대학, 기계공학부, KO
  3. 강충길교신저자부산대학교, 공과대학, 기계공학부, 정밀가공시스템전공, KO

초록

In this study, a rubber forming method is used to fabricate titanium bipolar plates for proton exchange membrane fuel cells. A titanium blank with a thickness of 0.1 mm is compressed using a stamping mold equipped with a 200-ton hydraulic press to fabricate bipolar plates. A forming experiment is carried out by changing different parameters such as the punch velocity, punch pressure, rubber thickness, rubber hardness, and draft angle of the channel. The optimum forming conditions are found to be a rubber thickness of 10 mm, rubber hardness equivalent to that of Shore A 20, punch velocity of 30 mm s(-1), punch pressure of 55 MPa, and punch draft angle of 30 degrees. The fabricated titanium bipolar plate is coated with a TiN layer. A single cell with a TiN-coated titanium bipolar plate is examined and compared to those with uncoated titanium and graphite bipolar plates. The initial performances (in terms of current densities) of the single cells with the uncoated titanium, TiN-coated titanium, and graphite bipolar plates are 396, 799, and 1160 mA cm(-2), respectively, at a cell voltage of 0.6 V. Copyright (C) 2014, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

키워드

Rubber formingDraft angleBipolar platesTitaniumTiN coatingPerformancePEM FUEL-CELLSFORMABILITY

식별자

WoS UID
000347576200065