본문 바로가기

Experimental Investigation on Galling Performance of Tool Steel in Stamping of UHSS Sheets

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q2Scopus Q1
피인용
Web of Science 12KCI 3
JCR IF
JCR 2013 1.5
ISSN
2234-7593

저자

  1. 최홍석제1저자부산대학교, 공과대학, 기계공학부, KO
  2. 김성귀부산대학교, 부속연구소, KO
  3. Seo, Pan-KiShinyoung Co Ltd, Tech Res Inst, KO
  4. 김병민부산대학교, 공과대학, 기계공학부, 정밀가공시스템전공, KO
  5. Cha, Byung-Chul한국생산기술연구원, Dongnam Reg Div, KO
  6. 고대철교신저자부산대학교, 나노과학기술대학, 나노메카트로닉스공학과, KO

초록

The objective of this study is to experimentally investigate the effect of surface roughness parameters on the galling performance of tool steel used in the stamping of ultra-high-strength steel (UHSS) sheets. The galling performance of uncoated and TiAlCrN coated AISI D2 tool steel was evaluated against a 1.4 mm-thick dual phase (DP) 980 UHSS sheet, using pin-on-flat surface test. For evaluating the galling performance of tool steel, the surface roughness parameters and topography were tested under three surface conditions: as-received (AS), as-received and post-polished (AS+P), and as-received coating (AS+C), whereas the sheet surface was tested under as-received and no post-treatment surface condition. The variation in the coefficient of friction was monitored as a function of sliding distance. The sliding distance at which severe galling began to occur owing to the transfer of sheet material to the tool surface was determined as the critical sliding distance for a sudden increase in the friction coefficient. Experimental results showed that a plateau-like topography, with low average surface roughness, negative skewness and high kurtosis value, improved the galling performance of tool steel. Additionally, the hard TiAlCrN coating of tool surface also effectively reduced galling tendency.

키워드

Galling performanceFriction coefficientSurface roughness parameterTool steelUltra high strength steel sheetStampingHIGH-STRENGTH STEELSSURFACE-ROUGHNESSWEARPARAMETERSRESISTANCEMECHANISMSCOATINGS

식별자

WoS UID
000337119500020
KCI
ART001879432