본문 바로가기

Effect of Chloride Precursors on the Stability of Solution-Processed Indium Zinc Oxide Thin-Film Transistors

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q3Scopus Q1
피인용
Web of Science 9
JCR IF
JCR 2012 1.067
ISSN
0021-4922

저자

  1. 이동희제1저자부산대학교, 공과대학, KO
  2. 박성민부산대학교, 공과대학, KO
  3. 양정일부산대학교, 공과대학, 전자공학과, KO
  4. 조동규부산대학교, 대학원, 계약학과, KO
  5. 우상현부산대학교, 대학원, 계약학과, KO
  6. 임유성부산대학교, 공과대학, 전자공학과, KO
  7. 김대국부산대학교, 대학원, 계약학과, KO
  8. 이문석교신저자부산대학교, 공과대학, 전자공학과, 전자공학전공, KO

초록

In this experiment, solution-processed indium zinc oxide (IZO) films were prepared by spin-coating the films as an active layer in thin-film transistors (TFTs). These films were coated with nitrate and a mixture of acetate-and chloride-based precursors to allow the IZO films to contain indium and zinc components. The solution-processed IZO-based TFT fabricated using a zinc acetate precursor for the IZO films exhibited a mobility of 2.83 cm(2) V-1 s(-1), an on/off current ratio of similar to 1 x 10(5), and a subthreshold swing value of 2.48 V/dec. The IZO-TFT with the zinc chloride precursor exhibited a mobility of 4.37 cm(2) V-1 s(-1), an on/off current ratio of similar to 1 x 10(3), and a subthreshold swing value of 6.44 V/dec. In comparison, the IZO-TFT with a mixture of zinc acetate and chloride precursors exhibited a mobility of 1.45 cm(2) V-1 s(-1), an on/off current ratio of similar to 1 x 10(5), and a subthreshold swing value of 1.83 V/dec. The first two devices suffered from a large threshold voltage (Vth) shift, >7 and >6 V, respectively, after a gate voltage of 20 V was applied for 2 h. In contrast, the device fabricated using the mixed precursors showed a higher stability, shifting about 1.7V under the same stress conditions. (C) 2013 The Japan Society of Applied Physics

키워드

ROOM-TEMPERATUREELECTRICAL-PROPERTIESHIGH-PERFORMANCECHANNEL LAYERZNOSEMICONDUCTOR

식별자

WoS UID
000325946500002