본문 바로가기

Effects of Particle Sizes on Sintering Behavior of 316L Stainless Steel Powder

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q1Scopus Q1
피인용
Web of Science 35
JCR IF
JCR 2012 1.627
ISSN
1073-5623

저자

  1. Park, Dong Yong제1저자포항공과대학교, Dept Mech Engn, Pohang 790784, KO
  2. 이규민부산대학교, 공과대학, 산업공학과, KO
  3. Park, Seong Jin포항공과대학교, Div Adv Nucl Engn, Pohang 790784, KO
  4. Kwon, Young-SamCetaTech Inc, Sacheon 664950, KO
  5. Otsuka, IsamuEpson Atmix Corp, Dev & Engn Dept, Hachinohe, JA

초록

In rapidly evolving powder injection molding technology, the wide prevalence of various microstructures demands the powders of smaller particle sizes. The effects of particle size on the sintering behavior are critical to not only shape retention of microstructure but also its mechanical properties. This study investigates the effects of three different particle sizes on the sintering behavior of the 316L stainless steel (STS316L) samples, prepared by powder injection molding, via the dilatometry experiments. For this purpose, the STS316L powders of three different mean particle sizes, i.e., 2.97, 4.16, and 8.04 mu m, were produced for STS316L. The samples for the dilatometry test were prepared through powder-binder mixing, injection molding, and solvent and thermal debinding. Dilatometry experiments were carried out with the samples in a H-2 atmosphere at three different heating rates of 3, 6, and 10 K/min. The shrinkage data obtained by dilatometry experiments was collected and analyzed to help understand the densification and the sintering behaviors in terms of particles size and heating rate. The master sintering curve (MSC) model was used to quantify the effects of particle sizes. In addition, we investigated the microstructure evolutions in terms of particles sizes.

키워드

DENSIFICATION BEHAVIORCURVE CONCEPTSMASTERMODELMICROSTRUCTUREMOLYBDENUMSIMULATION

식별자

WoS UID
000314366500034