본문 바로가기

Fabrication of micro spur gears by step powder extrusion of Zn-22wt%Al powder without sintering process

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q3Scopus Q2
피인용
Web of Science 2
JCR IF
JCR 2012 0.616
ISSN
1738-494X

저자

  1. 이경훈제1저자부산대학교, 부속연구소, Precis Mfg Syst Div, 소성가공, KO
  2. Lee, Jung-Min한국생산기술연구원, Dongnam Reg Div, KO
  3. Kim, Dong-Hwan한국국제대학교, KO
  4. 김병민교신저자부산대학교, 공과대학, 기계공학부, 정밀가공시스템전공, KO

초록

Micro spur gears were fabricated using the LIGA process and step powder extrusion without sintering. It is important to manufacture micro dies with high aspect ratios and determine the appropriate extrusion conditions for the micro-forming process. Micro-extrusion dies with close tolerance and long bearing length were produced by the LIGA process. Superplastic Zn-22wt%Al powders can deform under low stresses and exhibit a good micro-formability (average strain rate: 10(-3)s(-1); constant temperature: 250A degrees C). These powders were compacted to a cylinder (diameter: 3 mm; height: 10 mm) under 10kN compressive force, and sintered at 350A degrees C for two hours. Micro spur gear shafts were not produced upon extrusion because of the high working pressure on the die surface. For the reduction of the forming load, step powder extrusion was carried out on the compacted powder without a sintering process, but controlling the temperature dwelling period. This process has succeeded in fabricating micro-gear shafts.

키워드

LIGA processMicro dieGA Zn-22wt%AlStep powder extrusionMicro spur gearTECHNOLOGYSYSTEMSAL

식별자

WoS UID
000313795000019