본문 바로가기

Porous mullite ceramics derived from coal fly ash using a freeze-gel casting/polymer sponge technique

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q2Scopus Q1
저널
JOURNAL OF POROUS MATERIALS20(1) · pp.219 · 2013
피인용
Web of Science 45
JCR IF
JCR 2012 1.348
ISSN
1380-2224

저자

  1. Lee, JH제1저자부산대학교, 공과대학, 재료공학부, KO
  2. 최홍준부산대학교, 공과대학, 재료공학부, KO
  3. 윤석영부산대학교, 공과대학, 재료공학부, 무기재료공학전공, KO
  4. 김병규부산대학교, 공과대학, 고분자공학과, KO
  5. 박홍채교신저자부산대학교, 공과대학, 재료공학부, 무기재료공학전공, KO

초록

The objective of this study was to prepare highly porous mullite ceramics with relatively large-sized pores and improved compressive strength using a freeze/gel casting route combined with polymer sponge for recycling of coal fly ash into high value-added ceramics. In this work, a tertiary-butyl alcohol /coal fly ash slurry system with an appropriate addition of Al2O3 was used. A reticulated structure with large pore size of 220-300 mu m, which formed on burnout of polyurethane was obtained; then, the skeletons consisted mainly of more dense crystalline phases together with a few fine pores (< 3 mu m). The rod-shaped mullite crystals with an aspect ratio of > 3.7 (similar to 4 mu m in diameter) seen to have grown within the silicate melts existed. The compressive strength of the sintered porous materials increased in the reverse order of the degree of porosity, i.e. low porosity gave a high compressive strength. The porous materials with an average porosity of 61.6 %, sintered at 1600 A degrees C with 70 wt.% solid loading showed the maximum average compressive strength (similar to 45 MPa).

키워드

Coal fly ashTertiary butyl alcoholFreeze-gel casting/polymer spongePorousMullite ceramicsMICROSTRUCTUREFABRICATIONSCAFFOLDSKAOLIN

식별자

WoS UID
000312933400024