본문 바로가기

Mechanical properties and cutting performance of Cr-Al-N hybrid coated microtool for micro high-speed machining of flexible fine die

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q2Scopus Q1
저널
CURRENT APPLIED PHYSICS12 · pp.S14 · 2012
피인용
Web of Science 12
JCR IF
JCR 2011 1.9
ISSN
1567-1739

저자

  1. 김민욱제1저자부산대학교, KO
  2. 김광호부산대학교, 공과대학, 재료공학부, 무기재료공학전공, KO
  3. 강명창교신저자부산대학교, 대학원, 융합학부, KO
  4. Cho, S. H.한국기계연구원, Nano Machining Lab, KO
  5. Ryu, K. T.Finetech Co Ltd, KO

초록

In this paper, comparative studies on mechanical properties and cutting performance between CrN and Cr-Al-N coatings for high-speed machining of flexible fine die (FFD) were conducted. Ternary Cr-Al-N coatings, in which Al was incorporated into CrN, were synthesized onto WC-Co substrates using a hybrid coating system of arc ion plating and sputtering techniques. From XRD analysis the nanocomposite Cr-Al-N coatings were related to the composite microstructure consisting of the fine CrN crystallites and amorphous Si3N4. The average friction coefficient of Cr-Al-N coatings gradually decreased with Al content in CrN coatings. The values of tool wear for uncoated, CrN and Cr-Al-N coated tools were evaluated under a high-speed cutting condition using a vertical high-speed machining center. Consequently, the ternary Cr-Al-N coated micro-tool showed good cutting performance under micro highspeed machining of AISI W1-8 steel of hardness 52 HRC for flexible fine die. (C) 2012 Elsevier B.V. All rights reserved.

키워드

Flexible fine dieCr-Al-N coatingsMicro high-speed machiningMicro-hardnessTool wearCOATINGSCOMPOSITESYSTEMTOOLSWEAR

식별자

WoS UID
000310941500004