Properties of ITO (Indium Tin Oxide) Film Deposited by Ion-Beam-Assisted Sputter
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q3Scopus Q3
- 저널
- MOLECULAR CRYSTALS AND LIQUID CRYSTALS564 · pp.185 · 2012
- 피인용
- Web of Science 16
- JCR IF
- JCR 2011 0.58
- ISSN
- 1542-1406
저자
- Lee, Sung Ho제1저자교신저자Department of Materials and Energy Engineering, Kyungwoon University, South Korea
- Cho, Sang HyunDepartment of Materials Science and Engineering, Pusan National University, South Korea
- Kim, Hyo JinNano Convergence Research Team, Nano Convergence Practical Application Center, Daegu Technopark, South Korea
- Kim, Sung HongKorea Basic Science Institute, Daegu Center, South Korea
- Lee, Sang GeulKorea Basic Science Institute, Daegu Center, South Korea
- Song, Kyu HoNano Convergence Research Team, Nano Convergence Practical Application Center, Daegu Technopark, South Korea
- 송풍근Department of Materials Science and Engineering, Pusan National University, South Korea
초록
The ITO films were deposited on polyethylenenaphthalate at the room temperature using dc magnetron sputtering system with Ar ion-beam assist. The dc sputtering power was maintained at 200 W, and the Ar ion-beam power was varied from 20 to 70 W. The change in the resistance of the ITO films in the cyclic bending tests was significantly delayed with the Ar-ion-beam power 40 W. Also, the ITO film showed relatively low resistivity (5.39 x 10(-4) Omega cm). Thus. the ITO film showed good mechanical and electrical properties attributable to the effect of Ar ion bombardment on the thin film formation.
키워드
Magnetron sputteringion-beam assist sputtering (IBAS)indium tin oxideelectrical propertiescyclic bending testtransmittanceTHIN-FILMS
식별자
- WoS UID
- 000307934700023



로그인
연구물 목록으로