Finite Element Analysis of Corrugated Board under Bending Stress
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q4Scopus Q3
- 저널
- JOURNAL OF THE FACULTY OF AGRICULTURE KYUSHU UNIVERSITY57(1) · pp.181 · 2012
- 피인용
- Web of Science 11
- JCR IF
- JCR 2011 0.272
- ISSN
- 0023-6152
저자
- 박종민제1저자부산대학교, 생명자원과학대학, 바이오산업기계공학과, KO
- Kim, GhiseokMichigan State Univ, Dept Mech Engn, E Lansing, KO
- 권순홍부산대학교, 생명자원과학대학, 바이오산업기계공학과, KO
- 정성원부산대학교, 생명자원과학대학, 바이오산업기계공학과, KO
- 권순구부산대학교, 생명자원과학대학, 바이오산업기계공학과, KO
- 최원식부산대학교, 생명자원과학대학, 바이오산업기계공학과, KO
- Mitsuoka, Muneshi큐슈대학교, Grad Sch, Dept Bioprod Environm Sci, JA
- Inoue, Eiji큐슈대학교, Grad Sch, Dept Bioprod Environm Sci, JA
- Okayasu, Takashi큐슈대학교, Grad Sch, Dept Bioprod Environm Sci, JA
- Choe, Jungseob부산대학교, Dept Bioind Machinery Engn, KO
초록
Corrugated board is an engineering structure, whose strength characteristics depend on the cross section geometry and the material properties of liner and corrugated medium. Therefore, the board combination (combination of material for preparing corrugated board) of corrugated boards should be optimized with considering the quality characteristics of corrugated board demanded to achieve the optimum packaging design. The board combinations of corrugated boards can be determined by employing the configuration method for the paperboard stiffness and the basis weight. The results of board combinations can greatly affect the buckling resistance and compression strength of the box.(11,15) In order to analyze the effect of the configuration method for the board stiffness and the basis weight, on the flexural stiffness of corrugated board, we performed experiments based on cost- and time-consuming procedures. However, by using a simulation method such as finite element analysis (FEA) has the advantages such as saving of the time and cost in experiments and sample production as well as detailed analysis by adjusting several parameters. In the case of the simulation method, the estimation of reliability and reproducibility of the results should be strongly considered. In this study, we observed the strength optimal design conditions for the corrugated board combinations by analyzing the flexural stiffness index (PSI). The PEA method was used in the study using the four point loading conditions. We found that the difference between the PEA result and the test results were approximately 18-31%. However, it was estimated that the variations in PSI estimated by using both methods are similar. Therefore, we expect that the flexural balance for different. board combinations would be successfully analyzed on the basis of the qualitative comparison of PSI values corresponding to the combinations when the stiffness for each of the liner and the corrugating medium are assumed to be with 2-3 levels.
키워드
board combinationcorrugated boardfinite element analysisflexural stiffnessfour point bendhig testorthotropic materialSTRENGTHSTIFFNESSCARDBOARD
식별자
- WoS UID
- 000301399500030



로그인
연구물 목록으로