Evaluation of axial surface residual stress in 0.82-wt% carbon steel wire during multi-pass drawing process considering heat generation
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1Scopus Q1
- 저널
- MATERIALS & DESIGN34 · pp.363 · 2012
- 피인용
- Web of Science 33
- JCR IF
- JCR 2011 2.2
- ISSN
- 0264-1275
저자
- Lee, Sang-Kon제1저자한국생산기술연구원, Daegu Convergence R&D Ctr, Geen Transformat Technol Ctr, KO
- Kim, Dae-Woon현대, Corp Res & Dev Div, Crash Safety Engn Team, KO
- Jeong, Myeong-Sik한국생산기술연구원, Daegu Convergence R&D Ctr, Geen Transformat Technol Ctr, KO
- 김병민교신저자부산대학교, 공과대학, 기계공학부, 정밀가공시스템전공, KO
초록
In a multi-pass wire drawing process, inhomogeneous deformation through the cross section of a wire, heat generation resulting from plastic deformation, and friction generate residual stress in the drawn wire. The tensile residual stress in the wire deteriorates the mechanical properties of the drawn wire, with the maximum tensile residual stress occurring on its surface. This paper proposes a prediction model for the maximum axial residual stress that considers the inhomogeneous deformation and heat generation in a high-carbon (0.82-wt% C) drawn wire. An elastoplastic finite element (FE) analysis that considered the flow stress at a high strain range was carried out. Based on the results of this FE analysis, a stress prediction model was established. In order to verify the effectiveness of the prediction model, a multi-pass wire drawing experiment was performed. After performing the drawing experiment, the axial surface residual stress in the drawn wire was measured by X-ray diffraction. From the results, a close agreement was observed between the predicted residual stress and the measured residual stress. (C) 2011 Elsevier Ltd. All rights reserved.
키워드
DrawingMechanicalHigh carbon steel wireX-RAYHYDROGEN EMBRITTLEMENTMECHANICAL-PROPERTIESNEUTRON-DIFFRACTIONRODSDEFORMATIONCEMENTITEGEOMETRYFERRITEPHASES
식별자
- WoS UID
- 000298120300048



로그인
연구물 목록으로