Characteristics of amorphous Yb-doped ITO films deposited on polyimide substrate by DC magnetron sputtering
- 문서 유형
- 연구출판물 · 학술대회 발표논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q1
- 저널
- SURFACE & COATINGS TECHNOLOGY205 · pp.S318 · 2010
- 피인용
- Web of Science 4
- JCR IF
- JCR 2009 1.793
- ISSN
- 0257-8972
저자
- Jung, T부산대학교, KO
- Kim, S부산대학교, 공과대학, 재료공학부, KO
- 송풍근교신저자부산대학교, 공과대학, 재료공학부, 무기재료공학전공, KO
초록
The ITO and Yb-doped ITO (ITO:Yb) films were deposited on polyimide (PI) substrates by DC magnetron sputtering using ITO targets (doped-Yb: 0, 0.57, 3.2 and 7.75 at.%) containing different Yb ratios. Film deposition and post-annealing were carried out at room temperature and different temperatures (170 degrees C and 200 degrees C), respectively, in a pure Ar gas atmosphere at 1.0 Pa for 1 h. The ITO:Yb films had a higher crystallization temperature than that of the ITO films, which was attributed to Yb3+ atoms degrading the crystallinity of the ITO film. The ITO:Yb films also had good mechanical properties and a very flat surface morphology above the crystallization temperature of the ITO films (approximately 170 degrees C). The lowest resistivity of the polycrystalline ITO films obtained was 2.983 x 10(-4) Omega cm at 200 degrees C. On the other hand, the amorphous ITO:Yb films deposited from the 3.2 at.% Yb-doped ITO target at 170 degrees C had the lowest resistivity of 4.672 x 10(-4) Omega cm. The transmittance of all the ITO:Yb films was >80% in the visible region. (C) 2010 Elsevier B.V. All rights reserved.
키워드
ITODC magnetron sputteringAmorphous TCOYb-dopedFlexible substrateHigh thermal durabilityTIN-OXIDE-FILMSINDIUM OXIDETHIN-FILMSTEMPERATURE
식별자
- WoS UID
- 000286343200064



로그인
연구물 목록으로