Design of holographic polymer-dispersed liquid crystals based on solubility parameters
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널 순위
- JCR Q2
- 저널
- POLYMER INTERNATIONAL57(4) · pp.626 · 2008
- 피인용
- Web of Science 7
- JCR IF
- JCR 2007 1.557
- ISSN
- 0959-8103
저자
- 김은희제1저자Department of Polymer Science and Engineering, Pusan National University, South Korea
- 우주연Department of Polymer Science and Engineering, Pusan National University, South Korea
- Cho, Yeong HeeGraduate School of Materials Science, Japan Advanced Institute of Science and Technology (JAIST), Japan
- 김병규교신저자Department of Polymer Science and Engineering, Pusan National University, South Korea
초록
BACKGROUND: A slight change of polymer structure leads to a significantly different solubility parameter (SP), which is related to incompatibility and interface anchoring energy between a polymer and a liquid crystal (LC). RESULTS: Holographic gratings in polymer-dispersed liquid crystals have been fabricated based on various urethane acrylate oligomer sizes and type of reactive diluent at two LC loadings. A large SP gap, using N-vinylpyrrolidone as reactive diluent, gave much faster saturation of diffraction efficiency at higher level, but the grating failed to operate. On the contrary, films having a small SP gap, using 2-ethylhexyl acrylate, operated under 20V with a response time of about 10 ms, although their saturation of diffraction efficiency was relatively low. The results were interpreted in terms of morphology (determined using scanning electron microscopy), anchoring energy and resin elasticity. CONCLUSION: Low driving voltage and high diffraction efficiency are obtained by controlling the SP gap between LC and polymer. (c) 2007 Society of Chemical Industry.
식별자
- WoS UID
- 000254688800010



로그인
연구물 목록으로