본문 바로가기

Prediction of the Film Thickness Distribution and Pattern Change During Film Insert Thermoforming

문서 유형
연구출판물 · 학술지 논문
등재
SCIEScopus
저널 순위
JCR Q2
저널
POLYMER ENGINEERING AND SCIENCE49(11) · pp.2195 · 2009
피인용
Web of Science 12
JCR IF
JCR 2008 1.245
ISSN
0032-3888

저자

  1. 김국용제1저자Department of Precision Mechanical Engineering, Pusan National University, South Korea
  2. 이광오교신저자Department of Precision Mechanical Engineering, Pusan National University, South Korea
  3. 강성수Department of Precision Mechanical Engineering, Pusan National University, South Korea

초록

Various surface process methods have been developed to decorate plastic or metallic products. Film insert molding (FIM) is one of the methods that enhance the functional and/or aesthetic qualities of a product's surface. However, the drawbacks of FIM are that the thickness of the film can change, depending on the product configuration, and further, the pattern of the decorated film may change. Therefore, this article attempts to quantify the changes in the thickness and in the pattern of the decorated film during the FIM process. G'Sell's viscoelastic constitutive law was adopted to describe the rheological behavior of polymer film. A constant-velocity uniaxial tensile test at high temperature, which is a new method proposed in this research, was used to obtain the rheological parameters. We also suggested a visual method for predicting pattern change, which was validated by comparing analytical results with those of real products. POLYM. ENG. SCI., 49:2195-2203, 2009. (C) 2009 Society of Plastics Engineers

키워드

DEFORMATION METHODSSOLID POLYMERSPPE/PP BLENDABSSIMULATIONPOLYPROPYLENEINTERFACESHEETS

식별자

WoS UID
000271553200014