본문 바로가기

Characterizations of Adhesion Property, Morphology and Cure Reaction of Epoxy/Polyamide/MPD Reactive Blend with Imidazole(2E4MZ-CN) Catalyst

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널 순위
JCR Q3
저널
POLYMER-KOREA33(4) · pp.290 · 2009
피인용
Web of Science 2KCI 0
JCR IF
JCR 2008 0.61
ISSN
0379-153X

저자

  1. 송현우제1저자부산대학교
  2. 강학수부산대학교
  3. 김원호부산대학교
  4. 스테판말지프라운호퍼-IFAM
  5. 김병민부산대학교
  6. 최영선교신저자부산대학교

초록

The morphology and mechanical properties of epoxy/polyamide/MPD/2E4MZ-CN reactive blends with various amount of catalyst were investigated. The cure behaviors, mechanical strengths, and morphological changes of the epoxy blend systems were analyzed by using DSC, UTM, and SEM, respectively. The amount of catalyst ranged from 0 to 3 phr, and the cure reaction occurred at 170 degrees C for 30 min. The maximum peaks in heat flow during cure reactions appeared at slightly lower temperature with increasing catalyst content, indicating that the cure reactions start at lower temperature by adding catalyst and polyamide rarely hinders the cure reaction paths. The co-continuous morphology was found in epoxy/polyamide (20 phr) blends and by adding catalyst to the blends much clearer and uniform co-continuous phase was observed. The surface tension of the mechanical test specimen was increased due to the AP plasma surface treatment, and then adhesion strength was increased by over 20% by adding 2 phr of catalyst to the blends. When considering morphological tuning of the blends by means of catalyst incorporation, it is expected that the increased elongation and adhesion strength can be achieved in the structural adhesive systems.

식별자

WoS UID
000268476000003
KCI
ART001365942