본문 바로가기

Characteristics of ITO Films Deposited on a PET Substrate Under Various Deposition Conditions

문서 유형
연구출판물 · 학술지 논문
등재
KCISCIEScopus
저널
METALS AND MATERIALS INTERNATIONAL14(6) · pp.745 · 2008
피인용
Web of Science 32KCI 9
JCR IF
JCR 2007 1.424
ISSN
1598-9623

저자

  1. 이정락제1저자부산대학교
  2. 이동엽부산대학교
  3. 김도근한국기계연구원 부설 재료연구소
  4. 이군환한국기계연구원 부설 재료연구소
  5. 김양도부산대학교
  6. 송풍근교신저자부산대학교

초록

ITO films, with a thickness of 150 nm to 160 nm, were deposited on an unheated hard coated PET substrate or non-alkali glass substrate via dc magnetron sputtering. Depositions were carried out under the following various conditions: total gas pressure (P-tot), dc Sputtering power, target - substrate (T-S) distance, and O-2 or H-2 addition ratio. The ITO coated on the PET substrate showed relatively lower resistivity than that of the ITO coated on a glass substrate. Relatively small changes in the resistance (Delta R/R-o = 0.4) of the films were obtained for each deposition condition for the ITO/PET deposited under a sputtering power of 70 W, P-tot of 0.5 Pa, and T-S of 50 mm. It has been confirmed that the results of the electrical property showed concurrence with the results of the bending test. Specifically, the films that have a good electrical property showed only a small change in resistance to the increasing cycle number for each deposition condition. Therefore, it can be assumed that the increased resistance of the ITO films could be due to the formation of micro defects such as micro-cracks and the micro detachment of the ITO film from the flexible PET substrate.

식별자

WoS UID
000262121300013
KCI
ART001298147