본문 바로가기

Comparative studies on microstructure and mechanical properties of CrN, Cr-C-N and Cr-Mo-N coatings

문서 유형
연구출판물 · 학술대회 발표논문
등재
SCIEScopus
저널 순위
JCR Q2
피인용
Web of Science 102
JCR IF
JCR 2006 0.615
ISSN
0924-0136

저자

  1. 최은영제1저자부산대학교, 공과대학, 재료공학부, KO
  2. 강명창부산대학교, 대학원, 융합학부, KO
  3. 권동희부산대학교, 공과대학, 기계공학부, KO
  4. Shin, Dong Woo경상대학교, KO
  5. 김광호부산대학교, 공과대학, 재료공학부, KO

초록

Two different CrN-based ternary coatings were synthesized by hybrid coating system of arc ion plating (AIP) and DC magnetron sputtering technique. In this work, the effects of C addition for anion solid solution (Cr-C-N) and Mo addition for cation solid solution (Cr-Mo-N) on microstructures and mechanical properties of CrN coating were investigated. The microhardness values of Cr-C-N and Cr-Mo-N coatings were largely depended on C and Mo contents, respectively. The maximum hardness values of Cr-C-N and Cr-Mo-N coatings were 23 and 34 GPa, respectively. These values were much enhanced ones compared with 18 GPa of CrN coating. The enhanced hardness values of Cr-C-N and Cr-Mo-N coatings were explained with the solid solution hardening as well as defect hardening. The residual stresses in both coatings were compressive and less than 5 GPa. The average friction coefficient of Cr-C-N and Cr-Mo-N coatings was measured 0.5 and 0.4, respectively. The decreased friction coefficients of Cr-C-N and Cr-Mo-N coatings was explained by the formation of carbon rich transfer layer (or amorphous carbon layer) and the formation of MoO3 layer known as self-lubricant materials. (c) 2007 Elsevier B.V. All rights reserved.

식별자

WoS UID
000245898200125