Effect of nanoscratch conditions on both deformation behavior and wet-etching characteristics of silicon (100) surface
- 문서 유형
- 연구출판물 · 학술지 논문
- 등재
- SCIEScopus
- 저널
- WEAR261(3-4) · pp.328 · 2006
- 피인용
- Web of Science 38
- ISSN
- 0043-1648
저자
- Youn, S. W.부산대학교, KO
- 강충길부산대학교, 공과대학, 기계공학부, KO
초록
This paper investigates the effect of single-point diamond machining conditions, such as the Berkovich tip orientation (0 degrees, 45 degrees, and 90 degrees) and the normal load (0.1, 0.3, 0.5, 1, 2, 3, 4, 5 mN and 0.1 mu N), on the both deformation behavior and the chemical properties of single-crystal silicon through nanoscratch with 20 wt.% KOH-etching tests. The tip orientation had a significant influence on the coefficient of friction, which varied from 0.16 to 0.38, the material removal mode, and the KOH-etching property of silicon. In normal load ranges from 0.1 to 1 mN, the friction coefficient remarkably increased with decreasing normal. KOH-etching results showed that, as a whole, the size of etch-hillock structures increased with an increasing normal load, indicating that that the higher the load that is applied to the material surface, the more the etch-mask effect of the mechanically affected layer increases. Contrarily, the groove surface machined under a very low load (0.1 mu N) showed only the etch-promotion effect. The evolution of the morphology of a scratched Si(1 0 0) surface during the etching process was visualized by 20 wt.% KOH-etching tests under dipping times ranging from 0 to 30 min. The initial size of the etch-hillock structure was closely related to that of the contact zone between the diamond tip and materials. (c) 2005 Elsevier B.V. All rights reserved.
식별자
- WoS UID
- 000239678300012



로그인
연구물 목록으로