Skip to content

Study on the Wear Characteristics of Zn Precipitation-Strengthened Al Alloy

Document Type
Publications · Journal Article
Registered DB
SCIEScopus
Journal Ranking
JCR Q2Scopus Q2
Journal
ADVANCED ENGINEERING MATERIALS27(23) · 2025
Citation
Web of Science 1Scopus 1
FWCI (Scopus)
0.18
JCR IF
JCR 2024 3.3
ISSN
1438-1656

Authors

  1. Shin, Ji YongFirst authorPusan Natl Univ, Sch Mat Sci & Engn, Pusan 46241, South Korea
  2. Jeong, Hyun WooPusan Natl Univ, Sch Mat Sci & Engn, Pusan 46241, South Korea
  3. Kwon, Se HunCorresponding authorPusan Natl Univ, Sch Mat Sci & Engn, Pusan 46241, South Korea
  4. Kato, HidemiTohoku Univ, Inst Mat Res IMR, Sendai 9808577, Japan
  5. Choi, Eun-aeCorresponding authorKorea Inst Mat Sci KIMS, Extreme Mat Res Inst, Chang Won 51508, South Korea
  6. Han, Seung ZeonCorresponding authorKorea Inst Mat Sci KIMS, Extreme Mat Res Inst, Chang Won 51508, South Korea

Abstract

This study investigates the wear behavior of as-cast aluminum alloys containing Sn or Zn, with minor additions of Cu and Mg. The effects of alloy composition on hardness, friction coefficient, and wear resistance are evaluated through microstructural analysis and ball-on-disc sliding tests. Al-Zn alloys exhibit higher hardness and smaller deformation-affected zones compared to Al-Sn alloys, primarily due to precipitation strengthening. Wear test results of the Al-Zn alloys reveal an inverse relationship between hardness and mass loss. In contrast, Sn-containing alloys exhibit a proportional relationship between hardness and mass loss, which results in adhesive wear accompanied by the readsorption of Sn on the worn surface. Zn-containing alloys predominantly experienced abrasive wear, leading to more uniform and consistent surface morphology. Notably, the Al-17Zn-0.5Cu-0.1Mg (wt%) alloy exhibits both a low friction coefficient and minimal mass loss, indicating excellent wear resistance.

Keywords

Al-Sn alloysAl-Zn alloysfriction coefficientsmass lossprecipitation hardeningtribologyDRY SLIDING FRICTIONMECHANICAL-PROPERTIESALUMINUM-ALLOYSBEHAVIORMICROSTRUCTUREDUCTILITYFRACTUREPRESSURETENSILE

Identifiers

Scopus EID
2-s2.0-105020317919
WoS UID
001604708700001