Skip to content

Fabrication and Properties of Hard Coatings by a Hybrid PVD Method

Document Type
Publications · Review Article
Registered DB
SCIEScopus
Journal Ranking
JCR Q2Scopus Q2
Journal
LUBRICANTS13(9) · #390 · 2025
Citation
Web of Science 7Scopus 7
FWCI (Scopus)
0.32
JCR IF
JCR 2024 2.9
ISSN
2075-4442

Authors

  1. Zhang, RuiFirst authorGuangdong Univ Technol, Sch Electromech Engn, Guangzhou 510006, Peoples R China
  2. Wang, Qi MinCorresponding authorGuangdong Univ Technol, Sch Electromech Engn, Guangzhou 510006, Peoples R China
  3. Xu, YuxiangGuangdong Univ Technol, Sch Electromech Engn, Guangzhou 510006, Peoples R China
  4. Li, LishengGuangdong Huasheng Nanotechnol Co Ltd, Dongguan 523000, Peoples R China
  5. Kim, Kwang HoPusan Natl Univ, Global Frontier R&D Ctr Hybrid Interface Mat, San 30 Jangjeon Dong, Busan 609735, South Korea

Abstract

By integrating cathodic arc evaporation (CAE) with magnetron sputtering (MS) or high-power impulse magnetron sputtering (HiPIMS), hard coatings with diverse multicomponent compositions can be fabricated. Depending on the deposition conditions, the coatings with nano-composite or nano-multilayered microstructures are produced. During the mixing deposition conditions, nano-composite coatings are fabricated, which can be tailored to possess combining properties of super hardness, low friction coefficient, and excellent thermal/chemical stability. For the deposition with larger rotating periods, layer-by-layer deposition was observed. By the nano-multilayered coating design, superior mechanical properties (hardness >= 35 GPa), modulated residual stresses, and enhanced high-temperature properties can be obtained. In addition, lubricious elements, low friction (friction coefficient < 0.4), and low wear (<10(-5) mm(3)/N center dot m) both at ambient temperature and high temperature can be realized. Among these coatings, some have been specifically designed to achieve outstanding cutting performance in high-speed cutting applications. Several nitride and oxide hard coatings, such as AlTiN, TiAlN/TiSiN, AlCrN/Cu, and AlCrO, were deposited using a hybrid industrial physical vapor deposition (PVD) coating system. The microstructure, mechanical properties, and cutting performance of these coatings will be discussed.

Keywords

hybrid coating methodcathodic arc evaporationmagnetron sputteringhard coatingsmicrostructuremechanical propertiesSI-N COATINGSION-ASSISTED DEPOSITIONMECHANICAL-PROPERTIESUNBALANCED-MAGNETRONC-NTRIBOLOGICAL PROPERTIESWEAR BEHAVIORMICROSTRUCTUREFILMSTI

Identifiers

Scopus EID
2-s2.0-105017239806
WoS UID
001582267700001