Skip to content

A study on the measurement conditions for determining liquid entry pressure values of hydrophobic membranes

Document Type
Publications · Journal Article
Registered DB
SCIEScopus
Journal Ranking
JCR Q2Scopus Q2
Journal
CHEMICAL ENGINEERING RESEARCH & DESIGN208 · pp.184 · 2024
Citation
Web of Science 6Scopus 6
FWCI (Scopus)
0.49
JCR IF
JCR 2023 3.7
ISSN
0263-8762

Authors

  1. Pyo, MinsuFirst authorDaegu Univ, Dept Environm Engn, 201 Daegudae Ro, Gyongsan 38453, Gyeongbuk, South Korea
  2. Kim, DongyeonDaegu Univ, Dept Environm Engn, 201 Daegudae Ro, Gyongsan 38453, Gyeongbuk, South Korea
  3. Kim, HyungsooSungkyunkwan Univ, Grad Sch Water Resources, 2066 Seobu Ro, Suwon 440746, Gyeonggi Do, South Korea
  4. Jeong, SanghyunPusan Natl Univ, Dept Civil & Environm Engn, Busan 46241, South Korea
  5. Lee, Eui-JongCorresponding authorDaegu Univ, Dept Environm Engn, 201 Daegudae Ro, Gyongsan 38453, Gyeongbuk, South Korea

Abstract

Liquid entry pressure (LEP) is a method for evaluating resistance to wetting by gradually increasing the pressure on the membrane in contact with the liquid. Despite the potential impact of pressure increase rate on LEP value determination, there is a scarcity of related research. In this study, the relationship between membrane characteristics and LEP value was analyzed by increasing the pressure by 0.1 bar at intervals ranging from 10 s to 30 min, using solutions with or without 1 mM SDS. In addition, the wetting phenomenon in direct contact membrane distillation (DCMD) and the duration to resist water penetration at a certain pressure were evaluated using LEP and membrane characteristics. As the rate of pressure increase accelerated, the measured LEP value tended to rise, showing a relatively wide range of variation for the same membrane. To ensure the efficiency and reproducibility of LEP measurements, it is recommended to increase the pressure at 5-min intervals. While the durability of resistance to water penetration under relatively high pressure was greatly influenced by membrane thickness, membrane hydrophobicity was more crucial for preventing the wetting phenomenon in DCMD.

Keywords

Bubble point pressureHydrophobic membraneLiquid entry pressure (LEP)Membrane distillationSurface tensionTEMPERATUREMORPHOLOGYIMPACT

Identifiers

Scopus EID
2-s2.0-85197486406
WoS UID
001267030600001