Effects of Passivation with Cu and W on the Corrosion Properties of Super Duplex Stainless Steel PRE 42
- Document Type
- Publications · Journal Article
- Registered DB
- SCIEScopus
- Journal Ranking
- JCR Q2Scopus Q1
- Journal
- METALS14(3) · #284 · 2024
- Citation
- Web of Science 11Scopus 16
- FWCI (Scopus)
- 1.38
- JCR IF
- JCR 2023 2.6
- ISSN
- 2075-4701
Authors
- Kim, DohyungFirst authorPusan Natl Univ, Innovat Grad Educ Program Global High Tech Mat & P, Pusan 46241, South Korea
- Kim, SeongjunKorea Basic Sci Inst, Busan Ctr, Busan 46241, South Korea
- Park, JinyongKorea Basic Sci Inst, Busan Ctr, Busan 46241, South Korea
- Kim, Doo-InCorresponding authorPusan Natl Univ, Innovat Grad Educ Program Global High Tech Mat & P, Pusan 46241, South Korea
- Shin, Byung-hyunCorresponding authorKorea Basic Sci Inst, Busan Ctr, Busan 46241, South Korea
- Yoon, Jang-HeeCorresponding authorKorea Basic Sci Inst, Busan Ctr, Busan 46241, South Korea
Abstract
Carbon steel is subjected to several pretreatments to enable its use in highly corrosive environments, such as marine structures. However, its surface treatment is problematic owing to various processes, and these problems can be solved by replacing it with super duplex stainless steel (SDSS), which exhibits remarkable strength and corrosion resistance owing to its austenite and ferrite phases. EN 1.4410 and EN 1.4501 are the most extensively used SDSS grades in marine structures, as they exhibit exceptional strength and corrosion resistance in seawater. This study subjected EN 1.4410 and EN 1.4501 samples to specific heat treatment after casting and observed their structural alterations through field emission scanning electron microscopy. Their passivation states, with or without the Cu and W layers, were determined by examining their corrosion properties through open-circuit potential measurements, electrostatic polarisation tests, electrochemical impedance spectroscopy (EIS), and critical pitting temperature (CPT) analysis. The inclusion of Cu significantly improved the uniform corrosion resistance within the passivation layers, whereas the addition of W enhanced the pitting resistance (Epit, CPT). Additionally, the EIS analysis confirmed a double-layer structure in the passivation layer of EN 1.4501. Moreover, Cu did not act as a strengthening element of the passivation layer, whereas W significantly reinforced it.
Keywords
high corrosion steelsolution annealingsuper duplex stainless steeleffect of Cu and Wpassivation layercorrosion propertiespitting corrosionELECTROCHEMICAL-BEHAVIORPITTING CORROSIONMECHANICAL-PROPERTIESPHASEMICROSTRUCTUREPRECIPITATIONRESISTANCEELECTRODEFRACTION
Identifiers
- Scopus EID
- 2-s2.0-85189102050
- WoS UID
- 001192776700001



Login
Back to Publication list